* Added idle advance start threshold
On lower temp and/or on ethanol the engine need to crank more, without this my starter get a kick and the engine backfires.
This enable it only at 200 RPM below the target
* Use define to idle advance RPM threshold
Co-authored-by: Josh Stewart <josh@noisymime.org>
Currently the dwell limiter calculation considers rotary ignition to have more than 1 pulse per revolution. This only holds true for FC/FD type ignition which is wasted spark correctly resulting in 2 pulses per revolution. RX-8 type ignition however is fully sequential so there is only 1 pulse per revolution. As a result the dwell limiter is being calculated too low.
This change fixes the issue by correctly assuming 1 pulse per revolution in RX-8 type ignition
* Change "Aux in" 1-16 to 0-15 under prog outputs
Change "Aux in" 1-16 to 0-15 under "programmable outputs" menu to match the pin configuration page found under "local auxillary input channel configuration" menu.
* Update sensors.ino
* Update sensors.ino
* Match datalogging names to gauge names in ini
for ve/advance (current)
Co-authored-by: github-account-0 <91717711+github-account-0@users.noreply.github.com>
* Missing include
* 1. Add int16_byte class
2. Add axis factory function for int16_byte instances
(flyweight pattern)
* Separate out axis iteration and I/O conversions
* Optimize for size and performance.
* Fix unit test
* Consistent set of div100 functions
* Add typedef for trimTable3d
* Performance: use div100() function
when applying fuel trim corrections
* Silly ARM compiler!
* Unit test fixes
* Fix tests: expected & actual parameters were swapped
* div100(): add 8-bit overloads for completeness
* Fix unit tests
1. Force call to correct div100() overload
2. Use appropriately typed assertion
* Restore use of USE_LIBDIVIDE preprocessor symbol
* Add div360() - encapsulate libdivide use
* Fix copy/paste issue.
* Change "Aux in" 1-16 to 0-15 under prog outputs
Change "Aux in" 1-16 to 0-15 under "programmable outputs" menu to match the pin configuration page found under "local auxillary input channel configuration" menu.
* Update sensors.ino
* Update sensors.ino
Co-authored-by: github-account-0 <91717711+github-account-0@users.noreply.github.com>
* Coolant/RPM Protection
* removed test clear flash option
* Add new update section for coolantProtEnbl rather than using old area
Co-authored-by: Benas <bbrazdziunas@gavea.co.uk>
Co-authored-by: Josh Stewart <josh@noisymime.org>
The tableCrcCommand is used by TS to determine what calibrations (IAT, CLT and O2) are currently on the board. This is an optional command, however v3.1.07 unintentionally assumed it was implemented on all boards and gave a 'null' error if the command was not present.
This adds the command for all future versions, but previous releases will need to wait for theTS fix release
Update secondary tables to have tps * 2 in their lookup of fuelload2 and ignload2.
Dwell table and rotary split tables to match ignition load rather than fuelload.
Josh Stewart
tx_haggis
Vitor Moreno B. Sales
RempageR1
Daniel Tobias
Pasi Kemppainen
Corey-Harding
theKraid
DeionSi
Benas Brazdziunas
rafolg
Henry Wright