auto-sync

firmware/controllers/algo/rusefi_generated.h

@@ -72,6 +72,8 @@
 #define map_sensor_hwChannel_offset 252
 #define clt_offset 256
 #define clt_offset_hex 100
+#define clt_config_offset 256
+#define clt_config_offset_hex 100
 #define clt_tempC_1_offset 256
 #define clt_tempC_1_offset_hex 100
 #define clt_tempC_2_offset 260
@@ -92,6 +94,8 @@
 #define clt_s_h_c_offset_hex 124
 #define iat_offset 296
 #define iat_offset_hex 128
+#define iat_config_offset 296
+#define iat_config_offset_hex 128
 #define iat_tempC_1_offset 296
 #define iat_tempC_1_offset_hex 128
 #define iat_tempC_2_offset 300

firmware/integration/rusefi_config.txt

@@ -100,7 +100,8 @@ float[MAP_WINDOW_SIZE] samplingWindow;@brief MAP averaging angle duration, by RP
 air_pressure_sensor_config_s sensor
 end_struct
 
-struct ThermistorConf @brief Thermistor curve parameters
+
+struct_no_prefix thermistor_conf_s @brief Thermistor curve parameters
 float tempC_1;these values are in Celcuus;"*C",       1,     0,    -40, 200,     1
 float tempC_2;;"*C",       1,     0,    -40, 200,     1
 float tempC_3;;"*C",       1,     0,    -40, 200,     1
@@ -109,6 +110,10 @@ float resistance_2;;"Ohm",      1,     0,    0, 200000,     1
 float resistance_3;;"Ohm",      1,     0,    0, 200000,     1
 
 	float bias_resistor;;"Ohm",      1,     0,    0, 200000,     1
+end_struct
+
+struct ThermistorConf @brief Thermistor curve parameters
+	thermistor_conf_s config;
 
 	float s_h_a;
 	float s_h_b;

firmware/tunerstudio/rusefi.ini

@@ -40,7 +40,7 @@ enable2ndByteCanID = false
 
 ; see PAGE_0_SIZE in C source code    
 ; CONFIG_DEFINITION_START
-; this section was generated by ConfigDefinition.jar on Thu May 21 19:13:38 EDT 2015
+; this section was generated by ConfigDefinition.jar on Fri May 22 06:40:33 EDT 2015
 
 pageSize            = 15288
 page = 1