diff --git a/firmware/integration/rusefi_config.txt b/firmware/integration/rusefi_config.txt
index 83e195b72a..a304746281 100644
--- a/firmware/integration/rusefi_config.txt
+++ b/firmware/integration/rusefi_config.txt
@@ -1538,7 +1538,10 @@ float[FUEL_LOAD_COUNT] injPhaseLoadBins;;"Load",   1,   0.0,        0,  500.0,
 float[FUEL_RPM_COUNT] injPhaseRpmBins;;"RPM",	   1,   0.0,        0,  18000.0, 2
 
 tcubinary_table_t tcuSolenoidTable;
-uint8_t[1092] unused15136;;"units", 1, 0, -20, 100, 0
+
+float vssFilterReciprocal;+Good example: number of tooth on wheel, For Can 10 is a good number.;"Hz",   1,   0,   2.0,   20.0,   2
+
+uint8_t[1088] unused15136;;"units", 1, 0, -20, 100, 0
 
 ignition_table_t ignitionTable;
 float[IGN_LOAD_COUNT] ignitionLoadBins;;"Load",   1,   0.0,        0,  500.0,   2
diff --git a/firmware/tunerstudio/rusefi.input b/firmware/tunerstudio/rusefi.input
index ca8c67889e..e4b7cfc347 100644
--- a/firmware/tunerstudio/rusefi.input
+++ b/firmware/tunerstudio/rusefi.input
@@ -2810,10 +2810,14 @@ cmd_set_engine_type_default					= "@@TS_IO_TEST_COMMAND_char@@\x00\x31\x00\x00"
 	dialog = speedSensorCan
 		field = "Vss Car Type",						canVssNbcType, { enableCanVss }
 
+	dialog = vssFilter
+		field = "Filter Reciprocal",                      vssFilterReciprocal
+
 	dialog = speedSensorLeft, "Speed sensor config", yAxis
 		panel = speedSensorCan, { enableCanVss }
 	    panel = speedSensorAnalog, { enableCanVss == 0 }
 		field = "Enable CANbus VSS values",			enableCanVss, { canReadEnabled }
+		panel = vssFilter
 
 	dialog = speedSensor, "Speed sensor", xAxis
 		panel = speedSensorLeft