diff --git a/firmware/controllers/algo/engine_configuration_generated_structures.h b/firmware/controllers/algo/engine_configuration_generated_structures.h
index e3a1af1d60..281ca618d8 100644
--- a/firmware/controllers/algo/engine_configuration_generated_structures.h
+++ b/firmware/controllers/algo/engine_configuration_generated_structures.h
@@ -1,4 +1,4 @@
-// this section was generated automatically by ConfigDefinition.jar based on rusefi_config.txt Sun Jul 24 22:10:22 EDT 2016
+// this section was generated automatically by ConfigDefinition.jar based on rusefi_config.txt Sun Jul 24 22:23:59 EDT 2016
 // begin
 #ifndef ENGINE_CONFIGURATION_GENERATED_H_
 #define ENGINE_CONFIGURATION_GENERATED_H_
@@ -179,11 +179,9 @@ typedef struct {
 	 */
 	float flow;
 	/**
-	 * Base injector lag
-	 * See also extra vBatt correction curve
 	 * offset 4
 	 */
-	float lag;
+	float unusedlag;
 	/**
 	 * offset 8
 	 */
@@ -1906,4 +1904,4 @@ typedef struct {
 
 #endif
 // end
-// this section was generated automatically by ConfigDefinition.jar based on rusefi_config.txt Sun Jul 24 22:10:22 EDT 2016
+// this section was generated automatically by ConfigDefinition.jar based on rusefi_config.txt Sun Jul 24 22:23:59 EDT 2016
diff --git a/firmware/integration/rusefi_config.txt b/firmware/integration/rusefi_config.txt
index 29eaf4e7e5..8a7db708e3 100644
--- a/firmware/integration/rusefi_config.txt
+++ b/firmware/integration/rusefi_config.txt
@@ -172,7 +172,7 @@ int engineSnifferRpmThreshold;Engine sniffer would be disabled above this rpm;"R
 
 struct injector_s
 	float flow;+cc/min, cubic centimeter per minute\nBy the way, g/s = 0.125997881 * (lb/hr)\ng/s = 0.125997881 * (cc/min)/10.5\ng/s = 0.0119997981 * cc/min;"cm3/min",  1,     0,      0,   1000,   2
-	float lag;+Base injector lag\nSee also extra vBatt correction curve;"msec",     1,     0,      -10,   25.50,  2
+	float unusedlag;
 
 float[VBAT_INJECTOR_CURVE_SIZE] battLagCorrBins;;"V",        1,     0,      0.0,    20.0,   2
 float[VBAT_INJECTOR_CURVE_SIZE] battLagCorr;;"ms/V",     1,     0,      0.0,    50.0,   2
diff --git a/firmware/tunerstudio/rusefi.ini b/firmware/tunerstudio/rusefi.ini
index 5be5bfee82..e9300a93ca 100644
--- a/firmware/tunerstudio/rusefi.ini
+++ b/firmware/tunerstudio/rusefi.ini
@@ -42,14 +42,14 @@ enable2ndByteCanID = false
 
 ; see PAGE_0_SIZE in C source code    
 ; CONFIG_DEFINITION_START
-; this section was generated automatically by ConfigDefinition.jar based on rusefi_config.txt Sun Jul 24 22:10:22 EDT 2016
+; this section was generated automatically by ConfigDefinition.jar based on rusefi_config.txt Sun Jul 24 22:23:59 EDT 2016
 
 pageSize            = 16376
 page = 1
 	engineType					 = bits, S32, 0, [0:2], "AUDI_AAN", "DODGE_NEON_1995", "FORD_ASPIRE_1996", "FORD_FIESTA", "NISSAN_PRIMERA", "HONDA_ACCORD", "FORD_INLINE_6_1995", "GY6_139QMB"
 	engineSnifferRpmThreshold		= scalar, S32,	4,	"RPM", 1, 0, 0,30000, 0
 	injector_flow					= scalar, F32,	8,	"cm3/min", 1, 0, 0, 1000, 2
-	injector_lag					= scalar, F32,	12,	"msec", 1, 0, -10, 25.50, 2
+;skipping injector_unusedlag offset 12
 	injector_battLagCorrBins		= array, F32,	16,	[8],	"V", 1, 0, 0.0, 20.0, 2
 	injector_battLagCorr			= array, F32,	48,	[8],	"ms/V", 1, 0, 0.0, 50.0, 2
 	directSelfStimulation	= bits,    U32,   	80, [0:0], "false", "true"
@@ -679,7 +679,6 @@ page = 1
 ; total TS size = 16376
 [SettingContextHelp]
 	injector_flow = "cc/min, cubic centimeter per minute\nBy the way, g/s = 0.125997881 * (lb/hr)\ng/s = 0.125997881 * (cc/min)/10.5\ng/s = 0.0119997981 * cc/min"
-	injector_lag = "Base injector lag\nSee also extra vBatt correction curve"
 	directSelfStimulation = "Should trigger emulator push data right into trigger handling logic, eliminating the need for physical jumper wires?\nPS: Funny name, right? :)"
 	cranking_baseFuel = "Fuel squirt duration while cranking\nA number of curves adjust this value according to CLT/IAT/TPS etc"
 	cranking_rpm = "Cranking mode threshold. Special cranking logic controls fuel and spark while RPM is below this threshold"
@@ -913,7 +912,7 @@ fileVersion = { 20160702 }
       yBins       = map_samplingWindow
       gauge       = rpm
 
-   curve = injectorsDeadTime, "Injector Extra Dead Time Battery Correction"
+   curve = injectorsDeadTime, "Injector Dead Time by VBatt"
       columnLabel = "Voltage", "Dead Time"
       xAxis       =  8, 21, 10
       yAxis       = -3,  3, 10
@@ -1462,7 +1461,6 @@ cmd_test_idle_valve          = "w\x00\x17\x00\x01"
 
 ;			Engine->Injection Settings
 	dialog = injChars, "Injector Settings",	yAxis
-		field = "Base Injector Dead Time",		injector_lag
 		field = "Injector Flow",			injector_flow
 		field = "phase offset",				injectionOffset
 		
diff --git a/firmware/tunerstudio/rusefi.input b/firmware/tunerstudio/rusefi.input
index ba14fa8f02..8591a0f6ae 100644
--- a/firmware/tunerstudio/rusefi.input
+++ b/firmware/tunerstudio/rusefi.input
@@ -897,7 +897,7 @@ fileVersion = { 20160702 }
       yBins       = map_samplingWindow
       gauge       = rpm
 
-   curve = injectorsDeadTime, "Injector Extra Dead Time Battery Correction"
+   curve = injectorsDeadTime, "Injector Dead Time by VBatt"
       columnLabel = "Voltage", "Dead Time"
       xAxis       =  8, 21, 10
       yAxis       = -3,  3, 10
@@ -1446,7 +1446,6 @@ cmd_test_idle_valve          = "w\x00\x17\x00\x01"
 
 ;			Engine->Injection Settings
 	dialog = injChars, "Injector Settings",	yAxis
-		field = "Base Injector Dead Time",		injector_lag
 		field = "Injector Flow",			injector_flow
 		field = "phase offset",				injectionOffset