mirror of https://github.com/rusefi/rusefi.git
h81 step
This commit is contained in:
parent
793aacece0
commit
edb3dc616e
|
@ -1298,7 +1298,7 @@ int16_t tps2Max;Full throttle#2. tpsMax value as 10 bit ADC value. Not Voltage!\
|
|||
bit enableVerboseCan2Tx;+CAN broadcast using custom rusEFI protocol\nenable can_broadcast/disable can_broadcast
|
||||
bit can2ReadEnabled;enable can_read/disable can_read
|
||||
bit can2WriteEnabled;enable can_write/disable can_write
|
||||
bit unused1126
|
||||
bit stepperDcInvertedPins;+Enable if DC-motor driver (H-bridge) inverts the signals (eg. RZ7899 on Hellen boards)
|
||||
bit unused1127
|
||||
bit unused1128
|
||||
bit unused1129
|
||||
|
@ -1378,7 +1378,13 @@ tle8888_mode_e tle8888mode;
|
|||
uint8_t[3] unused2508;;"units", 1, 0, -20, 100, 0
|
||||
int16_t etbFreq;;"Hz", 1, 0, 0, @@ETB_HW_MAX_FREQUENCY@@, 0
|
||||
pid_s etbWastegatePid;
|
||||
uint8_t[4] unused2536;;"units", 1, 0, -20, 100, 0
|
||||
|
||||
#define stepper_num_micro_steps_e_enum "Full-Step (Default)", "INVALID", "Half-Step", "INVALID", "1/4 Micro-Step", "INVALID", "INVALID", "INVALID", "1/8 Micro-Step"
|
||||
custom stepper_num_micro_steps_e 1 bits, U08, @OFFSET@, [0:3], @@stepper_num_micro_steps_e_enum@@
|
||||
stepper_num_micro_steps_e stepperNumMicroSteps;+For micro-stepping, make sure that PWM frequency (etbFreq) is high enough;
|
||||
uint8_t stepperMinDutyCycle;+Use to limit the current when the stepper motor is idle, not moving (100% = no limit);"%", 1, 0, 0, 100, 0
|
||||
uint8_t stepperMaxDutyCycle;+Use to limit the max.current through the stepper motor (100% = no limit);"%", 1, 0, 0, 100, 0
|
||||
uint8_t unused2536;;"units", 1, 0, -20, 100, 0
|
||||
|
||||
angle_t[MAX_CYLINDER_COUNT iterate] timing_offset_cylinder;per-cylinder timing correction;"deg", 1, 0, -720, 720, 1
|
||||
|
||||
|
|
Loading…
Reference in New Issue