diff --git a/firmware/integration/rusefi_config.txt b/firmware/integration/rusefi_config.txt
index 2a0800e206..d13eee0f5a 100644
--- a/firmware/integration/rusefi_config.txt
+++ b/firmware/integration/rusefi_config.txt
@@ -1248,7 +1248,7 @@ tChargeMode_e tChargeMode;
 	int16_t coastingFuelCutClt;Fuel cutoff is disabled when the engine is cold.;"C", 1, 0, -100, 100, 0
 	
 	int16_t pidExtraForLowRpm;Increases PID reaction for RPM<target by adding extra percent to PID-error;"%", 1, 0, 0, 100, 0
-	bit useTableForDfcoMap,"Table","Fixed";Use a fixed MAP value as DFCO threshold, or vary the threshold with RPM.  This allows a softer cut at high RPMs where greater vaccuum is generated.
+	bit useTableForDfcoMap,"Table","Fixed";Fixed: MAP threshold cut fuel when conditions are met\nTable: Use a curve to vary the MAP threshold based on engine RPM
 	uint8_t[DFCO_RPM_MAP_TABLE] autoscale dfcoMapRpmValuesBins;;"RPM", 100, 0, 0, 17500, 0
 	uint8_t[DFCO_RPM_MAP_TABLE] autoscale dfcoMapRpmValues;DFCO will activate when operating below this curve. Used to allow a higher threshold at low RPM where less vaccuum is generated;"MAP", 1, 0, 0, 50, 0
 	int16_t coastingFuelCutMap;MAP value above which fuel injection is re-enabled.;"kPa", 1, 0, 0, 250, 0
diff --git a/firmware/tunerstudio/tunerstudio.template.ini b/firmware/tunerstudio/tunerstudio.template.ini
index 5d8153abbf..b3a5c8eb67 100644
--- a/firmware/tunerstudio/tunerstudio.template.ini
+++ b/firmware/tunerstudio/tunerstudio.template.ini
@@ -4481,7 +4481,7 @@ dialog = tcuControls, "Transmission Settings"
 		field = "Vehicle speed restore below",	coastingFuelCutVssLow, {coastingFuelCutEnabled}
 		field = "Cut fuel below TPS",			coastingFuelCutTps, {coastingFuelCutEnabled}
 		field = "Cut fuel below MAP mode",		useTableForDfcoMap, {coastingFuelCutEnabled}
-		field = "CUt fuel below MAP",		coastingFuelCutMap, {coastingFuelCutEnabled  && !useTableForDfcoMap}
+		field = "Cut fuel below MAP",		coastingFuelCutMap, {coastingFuelCutEnabled  && !useTableForDfcoMap}
 		field = "Fuel cut delay", dfcoDelay, {coastingFuelCutEnabled}
 		field = "Inhibit closed loop fuel after cut", noFuelTrimAfterDfcoTime, {coastingFuelCutEnabled}