ChibiOS/os/hal/platforms/STM8S/platform.dox

124 lines
4.0 KiB
Plaintext

/*
ChibiOS/RT - Copyright (C) 2006,2007,2008,2009,2010,
2011,2012 Giovanni Di Sirio.
This file is part of ChibiOS/RT.
ChibiOS/RT is free software; you can redistribute it and/or modify
it under the terms of the GNU General Public License as published by
the Free Software Foundation; either version 3 of the License, or
(at your option) any later version.
ChibiOS/RT is distributed in the hope that it will be useful,
but WITHOUT ANY WARRANTY; without even the implied warranty of
MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
GNU General Public License for more details.
You should have received a copy of the GNU General Public License
along with this program. If not, see <http://www.gnu.org/licenses/>.
*/
/**
* @defgroup STM8S STM8S Drivers
* @details This section describes all the supported drivers on the STM8S
* platform and the implementation details of the single drivers.
*
* @ingroup platforms
*/
/**
* @defgroup STM8S_HAL STM8S Initialization Support
* @details The STM8S HAL support is responsible for system initialization.
*
* @section stm8s_hal_1 Supported HW resources
* - CLK.
* .
* @section stm8s_hal_2 STM8S HAL driver implementation features
* - Clock tree initialization.
* - Clock source selection.
* .
* @ingroup STM8S
*/
/**
* @defgroup STM8S_PAL STM8S PAL Support
* @details The STM8S PAL driver uses the GPIO peripherals.
*
* @section stm8s_pal_1 Supported HW resources
* - GPIOA.
* - GPIOB.
* - GPIOC.
* - GPIOD.
* - GPIOE.
* - GPIOF.
* - GPIOG (where present).
* - GPIOH (where present).
* - GPIOI (where present).
* .
* @section stm8s_pal_2 STM8S PAL driver implementation features
* The PAL driver implementation fully supports the following hardware
* capabilities:
* - 8 bits wide ports.
* - Atomic set/reset/toggle functions because special STM8S instruction set.
* - Output latched regardless of the pad setting.
* - Direct read of input pads regardless of the pad setting.
* .
* @section stm8s_pal_3 Supported PAL setup modes
* The STM8S PAL driver supports the following I/O modes:
* - @p PAL_MODE_RESET.
* - @p PAL_MODE_UNCONNECTED.
* - @p PAL_MODE_INPUT.
* - @p PAL_MODE_INPUT_PULLUP.
* - @p PAL_MODE_OUTPUT_PUSHPULL.
* - @p PAL_MODE_OUTPUT_OPENDRAIN.
* .
* Any attempt to setup an invalid mode is ignored.
*
* @section stm8s_pal_4 Suboptimal behavior
* The STM8S GPIO is less than optimal in several areas, the limitations
* should be taken in account while using the PAL driver:
* - Bus/group writing is not atomic.
* - Pad/group mode setup is not atomic.
* .
* @ingroup STM8S
*/
/**
* @defgroup STM8S_SERIAL STM8S Serial Support
* @details The STM8S Serial driver uses the UART peripherals in a
* buffered, interrupt driven, implementation.
*
* @section stm8s_serial_1 Supported HW resources
* The serial driver can support any of the following hardware resources:
* - UART1.
* - UART2 (where present).
* - UART3 (where present).
* .
* @section stm8s_serial_2 STM8S Serial driver implementation features
* - Clock stop for reduced power usage when the driver is in stop state.
* - Each UART can be independently enabled and programmed. Unused
* peripherals are left in low power mode.
* - Fully interrupt driven.
* .
* @ingroup STM8S
*/
/**
* @defgroup STM8S_SPI STM8S SPI Support
* @details The SPI driver supports the STM8S SPI peripheral in an interrupt
* driven implementation.
* @note Being the SPI a fast peripheral, much care must be taken to
* not saturate the CPU bandwidth with an excessive IRQ rate. The
* maximum transfer bit rate is likely limited by the IRQ
* handling.
*
* @section stm8s_spi_1 Supported HW resources
* - SPI.
* .
* @section stm8s_spi_2 STM8S SPI driver implementation features
* - Clock stop for reduced power usage when the driver is in stop state.
* - Fully interrupt driven.
* .
* @ingroup STM8S
*/