diff --git a/firmware/hw_layer/sensors/CJ125.cpp b/firmware/hw_layer/sensors/CJ125.cpp
index 06833c39c0..1b5e32630c 100644
--- a/firmware/hw_layer/sensors/CJ125.cpp
+++ b/firmware/hw_layer/sensors/CJ125.cpp
@@ -14,6 +14,9 @@
 
 #if EFI_CJ125 || defined(__DOXYGEN__)
 
+// looks like 3v range should be enough, divider not needed
+#define EFI_CJ125_DIRECTLY_CONNECTED_UR TRUE
+
 #include "pin_repository.h"
 #include "hardware.h"
 #include "adc_inputs.h"
diff --git a/hardware/CJ125_board/known_issues.txt b/hardware/CJ125_board/known_issues.txt
index eda5e0793a..1f0b3aca82 100644
--- a/hardware/CJ125_board/known_issues.txt
+++ b/hardware/CJ125_board/known_issues.txt
@@ -4,4 +4,5 @@
  4) RESOLVED IN R0.3 add a note describing UR (R8) and UA (R15) low pass filter / slew rate limiter
  5) RESOLVED IN R0.3 Correct C9 should match C2 for 1kHz low pass filter. 
  6) RESOLVED IN R0.3 R12 is not routed right
- 7)                  voltage divider on UR and UA channels, 5V --> 3V
\ No newline at end of file
+ 7)                  voltage divider on UR and UA channels, 5V --> 3V (not clear if we need this)
+ 8)                  Remove R3 (connect ends) and remove C3
\ No newline at end of file