* Rename EFI_INTERNAL_FLASH to EFI_STORAGE_INT_FLASH
This define enables use of RE custom flash driver for storing
settings to internal flash.
* at_start_f435: enable MFS for settings storing in internal flash
* MRE: fix special build
* kinetis: fix flash_int.cpp vs flash_int.c mess
* at32: allow allowFlashWhileRunning()
* flash_main: supress warning
* at32_common.cpp: MCU type detection helper
* sayHello(): tick rate is CH_CFG_ST_FREQUENCY
* eficonsole: do isStm32F42x() check for STM32 only
* sayHello(): more info about AT32
* Update ChibiOS
* eficonsole: typo
* ENABLE_AUTO_DETECT_HSE: allow override from board config or board.mk
* Cleanup comments references to removed rtcWorks variable
* Allow board with no HSE oscillator
* OpenBLT: linker file: use last 16 bytes of ram for shared area
This area is used for communication between FW and OpenBLT.
* OpenBLT: startup: invalidate only DFU breadcumb from startup code
Same location (but different seed) is used for shared param's
signature in OpenBLT.
* OpenBLT: enable shared params
* OpenBLT: enable hooks
If 0x01 is stored in shared param idx=0, then stay in OpenBLT forever.
* Jump to OpenBLT: store proper shared param when OpenBLT is requested
TODO: calculate and store CRC too!
* OpenBLT: move shared_params to start of RAM
* Bootloader: Allocate 16 bytes at start of RAM for bootloader shared area
* OpenBLT: shared_params: reuse same .c and .h file for main application
* OpenBLT: shared_params: enable CRC check
* OpenBLT: no need to manualy set breadcumb before reset
* Revert "OpenBLT: startup: invalidate only DFU breadcumb from startup code"
This reverts commit 6b064714b953560227ae53e38355332cf9f46f7f.
* OpenBLT: guard for builds without OpenBLT
* OpenBLT: reboot to OpenBLT on CAN request with ID=0x667 and DLC=2
* config: options to enable OpenBLT on CAN interfaces
* OpenBLT: comments
* use backup ram, hard fault handler improvement
* wire it up
* upload elf
* s
* I guess I'll just use strncpy
* s
* what is it even complaining about?
* neat, we don't need a cast
* cypress and kinetis
* cleanup
* ci
* guard for tests
* I2C EEPROM support #3860
let's use contrib on all F4
* I2C EEPROM support #3860
let's use contrib on all F4, step 2
* I2C EEPROM support #3860
let's use contrib on all F4, step 3
* I2C EEPROM support #3860
let's use contrib on all F4, step 4
* I2C EEPROM support #3860
huh
* I2C EEPROM support #3860
all the way
Co-authored-by: rusefillc <sdfsdfqsf2334234234>
* ports: stm32f4: not all stm32f4xx are stm32f407, let board decide
* Do not include mcuconf_community.h in port's mcuconf.h usign relative path
as override file can be provided in board directory.