Update README.md
This commit is contained in:
parent
b3ac580117
commit
bc46be5b24
16
README.md
16
README.md
|
@ -6,6 +6,18 @@ Arduino based 2Step Launch Control Module similar to Bee*R for Honda/Acura
|
||||||
-All Honda/Acura engines that are 4cylinder and running with a distributor (mainly SerieB, D, F and H engines).
|
-All Honda/Acura engines that are 4cylinder and running with a distributor (mainly SerieB, D, F and H engines).
|
||||||
-It does works on Automatics cars.
|
-It does works on Automatics cars.
|
||||||
|
|
||||||
|
# Parts List
|
||||||
|
- 1x Arduino Nano V3 5V 16mhz atmega328p
|
||||||
|
- 1x 74HC00 Quad 2-input NAND gate (or 74LVC1G00 for a Single gate rather than a Quad gate)
|
||||||
|
- 2x 2N4401 transistors
|
||||||
|
- 6x 1K Ohms transistors
|
||||||
|
- 1x 1 to 10 Ohm transistors (can be replaced with a jumper or '0ohm' directly but a resistor make the circuit safer!)
|
||||||
|
- 2x B10K Potentiometer 0931
|
||||||
|
- 2x 2mm to 5mm Leds
|
||||||
|
- 1x 7805/78M05 5v voltage regulator
|
||||||
|
- 1x 100nF capacitor (104)
|
||||||
|
- 1x Diode (minimum of 20v), can be 1N4002, 1N4004, 1N4148, etc..
|
||||||
|
|
||||||
# Installation
|
# Installation
|
||||||
|
|
||||||
Inputs wires:
|
Inputs wires:
|
||||||
|
@ -13,10 +25,14 @@ Inputs wires:
|
||||||
- Potentiometer - Launch RPM selection
|
- Potentiometer - Launch RPM selection
|
||||||
- Potentiometer - Cut RPM selection
|
- Potentiometer - Cut RPM selection
|
||||||
- Activate Launch/2Step (sort to ground to activate)
|
- Activate Launch/2Step (sort to ground to activate)
|
||||||
|
- 12v Ignition On
|
||||||
|
- Ground
|
||||||
|
|
||||||
Outputs wires:
|
Outputs wires:
|
||||||
- ICM - Ignition Control Module singal Out for the distributor
|
- ICM - Ignition Control Module singal Out for the distributor
|
||||||
|
|
||||||
|
**You don't need to power the arduino from the USB, the 7805/78M05 5v regulator output 5v from the 12v Ignition input wire to power the arduino when the Car ignition key are turned On!**
|
||||||
|
|
||||||
# How to use the BM2Step
|
# How to use the BM2Step
|
||||||
|
|
||||||
1. Choose your desired Launch Control 2Step RPM with the potentiometer
|
1. Choose your desired Launch Control 2Step RPM with the potentiometer
|
||||||
|
|
Loading…
Reference in New Issue