modifide comments in Yun examples ShellCommands.ino ConsolePixel.ino

hardware/arduino/avr/libraries/Bridge/examples/ConsolePixel/ConsolePixel.ino

@@ -6,7 +6,7 @@
  it receives the character 'H', and turns off the LED when it
  receives the character 'L'.
  
- To see the Console, pick your Yun's name and IP address in the Port menu
+ To see the Console, pick your Yún's name and IP address in the Port menu
  then open the Port Monitor. You can also see it by opening a terminal window
  and typing 
  ssh root@ yourYunsName.local 'telnet localhost 6571'
@@ -24,17 +24,21 @@
  This example code is in the public domain.
  
  */
+
 #include <Console.h>
 
 const int ledPin = 13; // the pin that the LED is attached to
 char incomingByte;      // a variable to read incoming Console data into
 
 void setup() {
-  // initialize Console communication:
-  Bridge.begin();
-  Console.begin();
-  while(!Console);  // wait for the Console to open from the remote side
+  Bridge.begin();   // Initialize Bridge
+  Console.begin();  // Initialize Console
+
+  // Wait for the Console port to connect
+  while(!Console);
+
   Console.println("type H or L to turn pin 13 on or off");
+
   // initialize the LED pin as an output:
   pinMode(ledPin, OUTPUT);
 }

hardware/arduino/avr/libraries/Bridge/examples/ShellCommands/ShellCommands.ino

@@ -1,6 +1,6 @@
 
 /*
- Running shell coommands using Process class. 
+  Running shell commands using Process class. 
  
  This sketch demonstrate how to run linux shell commands
  using an Arduino Yún. It runs the wifiCheck script on the linino side
@@ -23,9 +23,11 @@
 #include <Process.h>
 
 void setup() {
-  // initialize the Bridge and Serial connections:
-  Bridge.begin();
-  Serial.begin(9600);
+  Bridge.begin();	// Initialize the Bridge
+  Serial.begin(9600);	// Initialize the Serial
+
+  // Wait until a Serial Monitor is connected.
+  while(!Serial);
 }
 
 void loop() {
@@ -40,12 +42,12 @@ void loop() {
 
   // Read command output. runShellCommand() should have passed "Signal: xx&":
   while (p.available()) {
-    int result = p.parseInt();                // look for an integer
-    int signal = map(result, 0, 100, 0, 255); // map result from 0-100 range to 0-255
-    analogWrite(9, signal);                   // set the brightness of LED on pin 9
-    Serial.println(result);                   // print the number as well
+    int result = p.parseInt();			// look for an integer
+    int signal = map(result, 0, 100, 0, 255);	// map result from 0-100 range to 0-255
+    analogWrite(9, signal);			// set the brightness of LED on pin 9
+    Serial.println(result);			// print the number as well
   } 
-  delay(5000);    // wait 5 seconds before you do it again
+  delay(5000);  // wait 5 seconds before you do it again
 }