Updating Makefile to derive target name from the current folder.
This commit is contained in:
parent
3460189d09
commit
1994278a7a
|
@ -7,36 +7,34 @@
|
|||
# Detailed instructions for using the makefile:
|
||||
#
|
||||
# 1. Copy this file into the folder with your sketch. There should be a
|
||||
# file with the extension .pde (e.g. foo.pde)
|
||||
# file with the same name as the folder and with the extension .pde
|
||||
# (e.g. foo.pde in the foo/ folder).
|
||||
#
|
||||
# 2. Below, modify the line containing "TARGET" to refer to the name of
|
||||
# of your program's file without an extension (e.g. TARGET = foo).
|
||||
#
|
||||
# 3. Modify the line containg "INSTALL_DIR" to point to the directory that
|
||||
# 2. Modify the line containg "INSTALL_DIR" to point to the directory that
|
||||
# contains the Arduino installation (for example, under Mac OS X, this
|
||||
# might be /Applications/arduino-0011).
|
||||
# might be /Applications/arduino-0012).
|
||||
#
|
||||
# 4. Modify the line containing "PORT" to refer to the filename
|
||||
# 3. Modify the line containing "PORT" to refer to the filename
|
||||
# representing the USB or serial connection to your Arduino board
|
||||
# (e.g. PORT = /dev/tty.USB0). If the exact name of this file
|
||||
# changes, you can use * as a wildcard (e.g. PORT = /dev/tty.USB*).
|
||||
# changes, you can use * as a wildcard (e.g. PORT = /dev/tty.usb*).
|
||||
#
|
||||
# 5. Set the line containing "MCU" to match your board's processor.
|
||||
# 4. Set the line containing "MCU" to match your board's processor.
|
||||
# Older one's are atmega8 based, newer ones like Arduino Mini, Bluetooth
|
||||
# or Diecimila have the atmega168. If you're using a LilyPad Arduino,
|
||||
# change F_CPU to 8000000.
|
||||
#
|
||||
# 6. At the command line, change to the directory containing your
|
||||
# 5. At the command line, change to the directory containing your
|
||||
# program's file and the makefile.
|
||||
#
|
||||
# 7. Type "make" and press enter to compile/verify your program.
|
||||
# 6. Type "make" and press enter to compile/verify your program.
|
||||
#
|
||||
# 8. Type "make upload", reset your Arduino board, and press enter to
|
||||
# 7. Type "make upload", reset your Arduino board, and press enter to
|
||||
# upload your program to the Arduino board.
|
||||
#
|
||||
# $Id$
|
||||
|
||||
TARGET = foo
|
||||
TARGET = $(notdir $(CURDIR))
|
||||
INSTALL_DIR = /Users/dmellis/Source/arduino/trunk/build/macosx/build/work
|
||||
PORT = /dev/tty.usb*
|
||||
UPLOAD_RATE = 19200
|
||||
|
|
Loading…
Reference in New Issue