7 Commits

Author	SHA1	Message	Date
Roger Clark	ff15d4815a	Added HID etc code	2016-07-18 17:35:02 +10:00
stevstrong	17cbf256d1	corrected defines needed when parity is used ... When the parity control is enabled, the computed parity is inserted at the MSB position (9th bit if M=1; 8th bit if M=0) and parity is checked on the received data. This excludes 9 bit long words + parity bit.	2015-11-19 11:50:13 +01:00
rogerclarkmelbourne	a1fdae2817	Made changes for Nucleo F103RB and Generic STM32F103C . Note this commit only works with these 2 boards, on all others Serial will not compile	2015-05-28 17:38:59 +10:00
rogerclarkmelbourne	fddefc13a9	Separated USB Serial functionality definitions from the BOOTLOADER_maple definition, so that generic boards can use USB serial without needing to have the bootloader and the disconnect hardware. NOTE. I have only tested the SERIAL_USB on the F103ZE board, it may not work on other generic boards	2015-04-25 15:28:45 +10:00
Roger Clark	f21592574f	Added serial config parameter support to HardwareSerial :: begin(), so that word length (of 8 or 9 bits), parity (None, Even or Odd) and 1 or 2 stop bits can now be set. Note the STM32 doesnt support all the word lengths supprted by AVR or SAM e.g. the hardware doesnt support 5,6 or 7 bit word lengths.	2015-03-04 22:59:11 +11:00
Roger Clark	244674ca81	Added dummy parameter to HardwareSerial begin() for device config. This is a work in progress, the config value is not used to control the hardware yet	2015-03-04 10:02:44 +11:00
Roger Clark	5f83c13285	renamed top level folder STM32F1XX to STM32F1 to correspond to other top level folder names e.g. STM32F3 and STM32F4	2015-02-24 20:13:04 +11:00