Roger Clark
|
388e8efeb6
|
Fixed issue in F1 and F3 with HardwareSerial read(), which should return -1 if no data in the input buffer, (be non-blocking)
|
2016-07-18 16:20:24 +10:00 |
stevstrong
|
7d2b43018f
|
bugfix - serial config parameter cannot be set
function usart_init must be called before usart_config_gpios_async
|
2015-11-19 14:01:23 +01:00 |
rogerclarkmelbourne
|
a1fdae2817
|
Made changes for Nucleo F103RB and Generic STM32F103C . Note this commit only works with these 2 boards, on all others Serial will not compile
|
2015-05-28 17:38:59 +10:00 |
|
rogerclarkmelbourne
|
fddefc13a9
|
Separated USB Serial functionality definitions from the BOOTLOADER_maple definition, so that generic boards can use USB serial without needing to have the bootloader and the disconnect hardware. NOTE. I have only tested the SERIAL_USB on the F103ZE board, it may not work on other generic boards
|
2015-04-25 15:28:45 +10:00 |
|
rogerclarkmelbourne
|
7b980c433e
|
Fix for missing UART 4 and 5 from STM32F104RE and STM32F103Z series boards. Note this code has not been fully tested
|
2015-04-20 09:50:33 +10:00 |
|
Roger Clark
|
f21592574f
|
Added serial config parameter support to HardwareSerial :: begin(), so that word length (of 8 or 9 bits), parity (None, Even or Odd) and 1 or 2 stop bits can now be set. Note the STM32 doesnt support all the word lengths supprted by AVR or SAM e.g. the hardware doesnt support 5,6 or 7 bit word lengths.
|
2015-03-04 22:59:11 +11:00 |
|
Roger Clark
|
244674ca81
|
Added dummy parameter to HardwareSerial begin() for device config. This is a work in progress, the config value is not used to control the hardware yet
|
2015-03-04 10:02:44 +11:00 |
|
Roger Clark
|
5f83c13285
|
renamed top level folder STM32F1XX to STM32F1 to correspond to other top level folder names e.g. STM32F3 and STM32F4
|
2015-02-24 20:13:04 +11:00 |