/*
 Chat  Server
 
 A simple server that distributes any incoming messages to all
 connected clients.  To use telnet to  your device's IP address and type.
 You can see the client's input in the serial monitor as well.
 Using an Arduino Wiznet Ethernet shield. 
 
 Circuit:
 * Ethernet shield attached to pins 10, 11, 12, 13
 * Analog inputs attached to pins A0 through A5 (optional)
 
 created 18 Dec 2009
 by David A. Mellis
 modified 9 Apr 2012
 by Tom Igoe
 modified 12 Aug 2013
 by Soohwan Kim
 Modified 18 Aug 2015
 by Vassilis Serasidis
 
 =========================================================
 Ported to STM32F103 on 18 Aug 2015 by Vassilis Serasidis

 <---- Pinout ---->
 W5x00 <--> STM32F103
 SS    <-->  PA4 <-->  BOARD_SPI1_NSS_PIN
 SCK   <-->  PA5 <-->  BOARD_SPI1_SCK_PIN
 MISO  <-->  PA6 <-->  BOARD_SPI1_MISO_PIN
 MOSI  <-->  PA7 <-->  BOARD_SPI1_MOSI_PIN
 =========================================================
 
 */

#include <SPI.h>
#include <Ethernet_STM.h>

// Enter a MAC address and IP address for your controller below.
// The IP address will be dependent on your local network.
// gateway and subnet are optional:
#if defined(WIZ550io_WITH_MACADDRESS) // Use assigned MAC address of WIZ550io
;
#else
byte mac[] = {0xDE, 0xAD, 0xBE, 0xEF, 0xFE, 0xED};
#endif  

IPAddress ip(192,168,1, 177);
IPAddress gateway(192,168,1, 1);
IPAddress subnet(255, 255, 255, 0);


// telnet defaults to port 23
EthernetServer server(23);
boolean alreadyConnected = false; // whether or not the client was connected previously

void setup() {
  // initialize the ethernet device
#if defined(WIZ550io_WITH_MACADDRESS)
  Ethernet.begin(ip, gateway, subnet);
#else
  Ethernet.begin(mac, ip, gateway, subnet);
#endif
  // start listening for clients
  server.begin();
  // Open serial communications and wait for port to open:
  Serial.begin(9600);
   while (!Serial) {
    ; // wait for serial port to connect. Needed for Leonardo only
  }
  

  Serial.print("Chat server address:");
  Serial.println(Ethernet.localIP());
}

void loop() {
  // wait for a new client:
  EthernetClient client = server.available();

  // when the client sends the first byte, say hello:
  if (client) {
    if (!alreadyConnected) {
      // clead out the input buffer:
      client.flush();    
      Serial.println("We have a new client");
      client.println("Hello, client!"); 
      alreadyConnected = true;
    } 

    if (client.available() > 0) {
      // read the bytes incoming from the client:
      char thisChar = client.read();
      // echo the bytes back to the client:
      server.write(thisChar);
      // echo the bytes to the server as well:
      Serial.write(thisChar);
    }
  }
}