*****************************************************************************
** ChibiOS/HAL - PWM driver demo for NUC123. **
*****************************************************************************
** TARGET **
The demo runs on a NUTINY-SDK-NUC123-V2.0 board with a NUC123SD4AN0 MCU.
** The Demo **
The application demonstrates the use of the NUC123 PWM driver. When successful,
pins 44 and 45 should carry a 750 Hz square wave, the duty cycle of which
sinusoidally oscillates between 0% and 100%. One channel is active high, and
the other is active low.
** Board Setup **
There are multiple ways to observe the PWM output:
- Attach channels of a logic analyzer to pins 44 & 45, and a ground pin. Set it
to trigger on either (but not both) the rising or falling edge of either (but
not both) channel.
** Build Procedure **
The demo has been tested using gcc version 9.3.1 (GNU Arm Embedded Toolchain 9-2020-q2-update).
Just modify the TRGT line in the makefile in order to use different GCC ports.
0aa26e0bee