36 lines
1.3 KiB
Plaintext
36 lines
1.3 KiB
Plaintext
*****************************************************************************
|
|
** ChibiOS/HAL - SERIAL driver demo for NUC123. **
|
|
*****************************************************************************
|
|
|
|
** TARGET **
|
|
|
|
The demo runs on a NUTINY-SDK-NUC123-V2.0 board with a NUC123SD4AN0 MCU.
|
|
|
|
** The Demo **
|
|
|
|
The application demonstrates the use of the NUC123 SERIAL driver. When successful,
|
|
SD0 should be used for serial communication with another serial device. The
|
|
target board should output `\nInitialized...\n` upon power-on, and should
|
|
immediately echo any character sent to it, with the standard C function toupper
|
|
called on it.
|
|
|
|
** Board Setup **
|
|
|
|
To use an external serial interface:
|
|
- Attach a serial bus to pins 21-24, and the GND:
|
|
21 - NUC123 RX
|
|
22 - NUC123 TX
|
|
23 - NUC123 nRTS (optional)
|
|
24 - NUC123 nCTS (optional)
|
|
- Ensure that the interface is set to the same configuration as the demo
|
|
(by default 57600 8N1)
|
|
|
|
To use the ICE's on-board USB-serial interface:
|
|
- Set SW2 1-4 to ON
|
|
- Connect a USB cable from a workstation to J5
|
|
|
|
** Build Procedure **
|
|
|
|
The demo has been tested using gcc version 9.3.1 (GNU Arm Embedded Toolchain 9-2020-q2-update).
|
|
Just modify the TRGT line in the makefile in order to use different GCC ports.
|