/* * Licensed under ST Liberty SW License Agreement V2, (the "License"); * You may not use this file except in compliance with the License. * You may obtain a copy of the License at: * * http://www.st.com/software_license_agreement_liberty_v2 * * Unless required by applicable law or agreed to in writing, software * distributed under the License is distributed on an "AS IS" BASIS, * WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied. * See the License for the specific language governing permissions and * limitations under the License. */ /** * @file SPC5xx/SIU_v1/pal_lld.c * @brief SPC5xx SIU low level driver code. * * @addtogroup PAL * @{ */ #include "ch.h" #include "hal.h" #if HAL_USE_PAL || defined(__DOXYGEN__) /*===========================================================================*/ /* Driver local definitions. */ /*===========================================================================*/ /*===========================================================================*/ /* Driver exported variables. */ /*===========================================================================*/ /*===========================================================================*/ /* Driver local variables and types. */ /*===========================================================================*/ #if defined(SPC5_SIU_SYSTEM_PINS) static const unsigned system_pins[] = {SPC5_SIU_SYSTEM_PINS}; #endif /*===========================================================================*/ /* Driver local functions. */ /*===========================================================================*/ /*===========================================================================*/ /* Driver interrupt handlers. */ /*===========================================================================*/ /*===========================================================================*/ /* Driver exported functions. */ /*===========================================================================*/ /** * @brief SPC5xx I/O ports configuration. * * @param[in] config the STM32 ports configuration * * @notapi */ void _pal_lld_init(const PALConfig *config) { unsigned i; /* Initialize PCR registers for defined pads.*/ i = 0; while (config->inits[i].pcr_value != 0) { SIU.GPDO[config->inits[i].pcr_index].R = config->inits[i].gpdo_value; SIU.PCR[config->inits[i].pcr_index].R = config->inits[i].pcr_value; i++; } } /** * @brief Reads a group of bits. * * @param[in] port port identifier * @param[in] mask group mask * @param[in] offset group bit offset within the port * @return The group logical states. * * @notapi */ ioportmask_t _pal_lld_readgroup(ioportid_t port, ioportmask_t mask, uint_fast8_t offset) { (void)port; (void)mask; (void)offset; return 0; } /** * @brief Writes a group of bits. * * @param[in] port port identifier * @param[in] mask group mask * @param[in] offset group bit offset within the port * @param[in] bits bits to be written. Values exceeding the group width * are masked. * * @notapi */ void _pal_lld_writegroup(ioportid_t port, ioportmask_t mask, uint_fast8_t offset, ioportmask_t bits) { (void)port; (void)mask; (void)offset; (void)bits; } /** * @brief Pads mode setup. * @details This function programs a pads group belonging to the same port * with the specified mode. * * @param[in] port the port identifier * @param[in] mask the group mask * @param[in] mode the mode * * @notapi */ void _pal_lld_setgroupmode(ioportid_t port, ioportmask_t mask, iomode_t mode) { unsigned pcr_index = (unsigned)(port * PAL_IOPORTS_WIDTH); ioportmask_t m1 = 0x8000; while (m1) { if (mask & m1) SIU.PCR[pcr_index].R = mode; m1 >>= 1; ++pcr_index; } } #endif /* HAL_USE_PAL */ /** @} */