ChibiOS/demos/AVR/TEST-SUITE-NIL
edolomb 45f105e043 Added I2C slave support for ST low level drivers.
Added I2C-MASTER_SLAVE multi demo.
Updated halconf.h 

git-svn-id: svn://svn.code.sf.net/p/chibios/svn/trunk@16984 27425a3e-05d8-49a3-a47f-9c15f0e5edd8
2025-03-25 14:34:20 +00:00
..
cfg Added I2C slave support for ST low level drivers. 2025-03-25 14:34:20 +00:00
Makefile Fix variable name used to exclude the generic flash driver from AVR build. 2024-12-15 09:19:32 +00:00
main.c Mass change: Source code convention changed from CRLF to just CR (Unix). 2022-08-29 15:54:32 +00:00
readme.txt Mass EOL change to Unix mode. 2022-12-11 14:52:30 +00:00

readme.txt

*****************************************************************************
** ChibiOS/NIL port for Atmel AVR ATmega2560.                              **
*****************************************************************************

** TARGET **

The demo runs on an Arduino Mega board.

** The Demo **

One thread prints a message to the serial console, which is available on
the board USB connector (FT232 converter).

Another thread toggles the LED on PB7 (pin 13 on Arduino IDE) every 500ms.

** Build Procedure **

The demo was built using the GCC AVR toolchain. It should build with WinAVR too!

** Notes **

This demo runs natively so the Arduino bootloader must be removed and the FUSEs
reprogrammed. The values used for fuses are LFUSE=0xe7 and HFUSE=0x99.