56 lines
2.0 KiB
Markdown
56 lines
2.0 KiB
Markdown
|
# RSSI
|
||
|
|
||
|
RSSI is a measurement of signal strength and is very handy so you know when your aircraft is going out of range or if it is suffering RF interference.
|
||
|
|
||
|
Some receivers have RSSI outputs. 3 types are supported.
|
||
|
|
||
|
1. RSSI via PPM channel
|
||
|
1. RSSI via Parallel PWM channel
|
||
|
1. RSSI via ADC with PPM RC that has an RSSI output - aka RSSI ADC
|
||
|
|
||
|
## RSSI via PPM
|
||
|
|
||
|
Configure your receiver to output RSSI on a spare channel, then select the channel used via the CLI.
|
||
|
|
||
|
e.g. if you used channel 9 then you would set:
|
||
|
|
||
|
```
|
||
|
set rssi_channel = 9
|
||
|
```
|
||
|
Note: Some systems such as EZUHF invert the RSSI ( 0 = Full signal / 100 = Lost signal). To correct this problem you can invert the channel input so you will get a correct reading by using command:
|
||
|
|
||
|
```
|
||
|
set rssi_invert = ON
|
||
|
```
|
||
|
Default is set to "OFF" for normal operation ( 100 = Full signal / 0 = Lost signal).
|
||
|
|
||
|
## RSSI via Parallel PWM channel
|
||
|
|
||
|
Connect the RSSI signal to any PWM input channel then set the RSSI channel as you would for RSSI via PPM
|
||
|
|
||
|
## RSSI ADC
|
||
|
|
||
|
Connect the RSSI signal to the RC2/CH2 input. The signal must be between 0v and 3.3v.
|
||
|
Use inline resistors to lower voltage if required; inline smoothing capacitors may also help.
|
||
|
A simple PPM->RSSI conditioner can easily be made. See the PPM-RSSI conditioning.pdf for details.
|
||
|
|
||
|
Under CLI :
|
||
|
- enable using the RSSI_ADC feature : `feature RSSI_ADC`
|
||
|
- set the RSSI_SCALE parameter (between 1 and 255) to adjust RSSI level according to your configuration. The raw ADC value is divided by the value of this parameter.
|
||
|
|
||
|
Note: Some systems invert the RSSI ( 0 = Full signal / 100 = Lost signal). To correct this problem you can invert the input so you will get a correct reading by using command:
|
||
|
|
||
|
```
|
||
|
set rssi_invert = ON
|
||
|
```
|
||
|
|
||
|
## RSSI_SCALE setup method:
|
||
|
|
||
|
- set rssi_scale = 100. The displayed percentage will then be the raw ADC value.
|
||
|
- turn on RX (close to board). RSSI value should vary a little.
|
||
|
- Update rssi_scale to the maximum RSSI value previously measured.
|
||
|
|
||
|
FrSky D4R-II and X8R supported.
|
||
|
|
||
|
The feature can not be used when RX_PARALLEL_PWM is enabled.
|