rusefi
/
atbetaflight
mirror of https://github.com/rusefi/atbetaflight.git
1
0
Fork 0
Code Issues Packages Projects Releases Wiki Activity

Updating documentation.

This commit is contained in:
Dominic Clifton 2014-05-24 21:04:30 +01:00
parent d928404919
commit 49781b5080
2 changed files with 5 additions and 2 deletions
Show Stats Download Patch File Download Diff File Expand all files Collapse all files

5
docs/Failsafe.md
View File

@ -42,7 +42,7 @@ Delay after failsafe activates before motors finally turn off. If you fly high
### `failsafe_throttle`
Throttle level used for landing. Specify a value the causes the aircraft to descend at about 1M/sec.
Throttle level used for landing. Specify a value the causes that aircraft to descend at about 1M/sec.
Use standard RX usec values. See Rx documentation.
@ -60,4 +60,5 @@ Only valid when using Parallel PWM or PPM receivers.
This setting helps catch when your RX stops sending any data when the RX looses signal.
With a Graupner GR-24 configured for PWM output with failsafe on channels 1-4 set to OFF on the receiver then this setting at it's default value will allow failsafe to be activated.
With a Graupner GR-24 configured for PWM output with failsafe on channels 1-4 set to OFF in the receiver settings
then this setting, at it's default value, will allow failsafe to be activated.

2
docs/Telemetry.md
View File

@ -30,6 +30,8 @@ See the Configuration examples in the documentation for details on how to enable
HoTT telemetry can be used when the TX and RX pins of a serial port are connected using a diode and a single wire to the T port on a HoTT receiver.
Only Electric Air Modules and GPS Modules are emulated, remember to enable them on your transmitter - in the Telemetry Menu on the MX-20.
Serial ports use two wires but HoTT uses a single wire so some electronics are required so that the signals don't get mixed up.
Connect as follows: