rusefi
/
atbetaflight
mirror of https://github.com/rusefi/atbetaflight.git
1
0
Fork 0
Code Issues Packages Projects Releases Wiki Activity

Updating documentation.

This commit is contained in:
Dominic Clifton 2014-05-24 21:04:30 +01:00
parent d928404919
commit 49781b5080
2 changed files with 5 additions and 2 deletions
Show Stats Download Patch File Download Diff File Expand all files Collapse all files

5
docs/Failsafe.md
View File

@ -42,7 +42,7 @@ Delay after failsafe activates before motors finally turn off. If you fly high
### `failsafe_throttle` ### `failsafe_throttle`
Throttle level used for landing. Specify a value the causes the aircraft to descend at about 1M/sec. Throttle level used for landing. Specify a value the causes that aircraft to descend at about 1M/sec.
Use standard RX usec values. See Rx documentation. Use standard RX usec values. See Rx documentation.
@ -60,4 +60,5 @@ Only valid when using Parallel PWM or PPM receivers.
This setting helps catch when your RX stops sending any data when the RX looses signal. This setting helps catch when your RX stops sending any data when the RX looses signal.
With a Graupner GR-24 configured for PWM output with failsafe on channels 1-4 set to OFF on the receiver then this setting at it's default value will allow failsafe to be activated. With a Graupner GR-24 configured for PWM output with failsafe on channels 1-4 set to OFF in the receiver settings
then this setting, at it's default value, will allow failsafe to be activated.

2
docs/Telemetry.md
View File

@ -30,6 +30,8 @@ See the Configuration examples in the documentation for details on how to enable
HoTT telemetry can be used when the TX and RX pins of a serial port are connected using a diode and a single wire to the T port on a HoTT receiver. HoTT telemetry can be used when the TX and RX pins of a serial port are connected using a diode and a single wire to the T port on a HoTT receiver.
Only Electric Air Modules and GPS Modules are emulated, remember to enable them on your transmitter - in the Telemetry Menu on the MX-20.
Serial ports use two wires but HoTT uses a single wire so some electronics are required so that the signals don't get mixed up. Serial ports use two wires but HoTT uses a single wire so some electronics are required so that the signals don't get mixed up.
Connect as follows: Connect as follows: