clean up pretty useless console commands
(cherry picked from commit c71ba44d61
)
This commit is contained in:
parent
32eb0b8ad2
commit
5ceff5fb78
|
@ -44,7 +44,6 @@ void setDodgeNeon1995EngineConfiguration() {
|
|||
|
||||
setWholeTimingTable_d(12);
|
||||
|
||||
// set cranking_injection_mode 0
|
||||
engineConfiguration->crankingInjectionMode = IM_SIMULTANEOUS;
|
||||
// set injection_mode 1
|
||||
engineConfiguration->injectionMode = IM_SEQUENTIAL;
|
||||
|
@ -91,7 +90,6 @@ void setDodgeNeon1995EngineConfiguration() {
|
|||
|
||||
engineConfiguration->mapErrorDetectionTooHigh = 120;
|
||||
|
||||
// set injection_pin_mode 0
|
||||
engineConfiguration->injectionPinMode = OM_DEFAULT;
|
||||
|
||||
// Frankenstein: high side #1: PE8
|
||||
|
@ -101,7 +99,6 @@ void setDodgeNeon1995EngineConfiguration() {
|
|||
engineConfiguration->ignitionPins[1] = Gpio::Unassigned;
|
||||
engineConfiguration->ignitionPins[2] = Gpio::E10; // // Frankenstein: high side #2
|
||||
|
||||
// set ignition_pin_mode 0
|
||||
engineConfiguration->ignitionPinMode = OM_DEFAULT;
|
||||
|
||||
engineConfiguration->clt.config = {0, 30, 100, 32500, 7550, 700, 2700};
|
||||
|
|
|
@ -114,7 +114,6 @@ void common079721_2351() {
|
|||
|
||||
engineConfiguration->fuelPumpPin = Gpio::Unassigned; // fuel pump is not controlled by ECU on this engine
|
||||
|
||||
// set cranking_injection_mode 0
|
||||
engineConfiguration->crankingInjectionMode = IM_SIMULTANEOUS;
|
||||
// set injection_mode 2
|
||||
engineConfiguration->injectionMode = IM_BATCH;
|
||||
|
|
|
@ -455,7 +455,7 @@ uint16_t engineSnifferRpmThreshold;Engine sniffer would be disabled above this r
|
|||
|
||||
struct injector_s
|
||||
float flow;This is your injector flow at the fuel pressure used in the vehicle. cc/min, cubic centimetre per minute\nBy the way, g/s = 0.125997881 * (lb/hr)\ng/s = 0.125997881 * (cc/min)/10.5\ng/s = 0.0119997981 * cc/min;"cm3/min", 1, 0, 0, 99999, 2
|
||||
float[VBAT_INJECTOR_CURVE_SIZE] battLagCorrBins;set_flat_injector_lag LAG\nset_injector_lag VOLTAGE LAG;"volts", 1, 0, 0, 20, 2
|
||||
float[VBAT_INJECTOR_CURVE_SIZE] battLagCorrBins;;"volts", 1, 0, 0, 20, 2
|
||||
float[VBAT_INJECTOR_CURVE_SIZE] battLagCorr;ms delay between injector open and close dead times;"ms", 1, 0, 0, 50, 2
|
||||
end_struct
|
||||
|
||||
|
@ -619,7 +619,7 @@ custom spi_device_e 1 bits, U08, @OFFSET@, [0:2], "Off", "SPI1", "SPI2", "SPI3",
|
|||
uint8_t boostControlSafeDutyCycle;Duty cycle to use in case of a sensor failure. This duty cycle should produce the minimum possible amount of boost. This duty is also used in case any of the minimum RPM/TPS/MAP conditions are not met.;"%", 1, 0, 0, 100, 0
|
||||
adc_channel_e mafAdcChannel
|
||||
|
||||
float globalFuelCorrection;set global_fuel_correction X;"coef", 1, 0, 0, 1000, 2
|
||||
float globalFuelCorrection;;"coef", 1, 0, 0, 1000, 2
|
||||
|
||||
float adcVcc;;"volts", 1, 0, 0, 6, 3
|
||||
float mapCamDetectionAnglePosition;;"Deg", 1, 0, 0, 360, 0
|
||||
|
|
Loading…
Reference in New Issue