* configurable stoich ratio
* afr table always in gas afr
* default
* typo
* use defined ratio
* do it in config too
* missed a spot
* oops wrong one
Co-authored-by: Matthew Kennedy <makenne@microsoft.com>
* add redundant sensor
* add tests
* add configure, info printing
* tests
* tests
* partial hookup
* fix
* fix
* bad makefile merge
* use second TPS config
* update test
* update test
* sensor names
* set second pin by default
* fix auto cal
* auto cal both sensors
* add reconfigure of secondary sensors
* gobblin' up your ram
* slow down write a little bit
* put split in debug gauge
* s
Co-authored-by: Matthew Kennedy <matthew@mck-mbp-15.local>
Co-authored-by: Matthew Kennedy <makenne@microsoft.com>
* add new fields
* add tps 2 secondary
* sensible error detection limits
* UI mods
* grey out as appropriate
* defaults
* either it's unused or its not
* Update ChibiOS
* Fix coexistance of ChibiOS and our flash drivers
* Add 'int' = internal prefix for all on-chip flash functions
This avoid conflict with ChibiOS functions available after
enabling HAL_USE_EFL
* Exclude ChibiOS flash driver from bootloader
* Makefile magic?
* Kinetis: fix build after ChibiOS update and switching to SMART_BUILD
* Bootloader now use SMART_BUILD too
* multispark prototype
* only multispark if not cut
* typo
* do some reasonableish math
* consume cfg
* todo
* bad merge
* move math out of engine2.cpp
* engine state config
* consume generated
* use new
* hand generate
* doc, debugging
* debug channel names
* don't depend on rpmcalc
* safer, fix math
* tests
* default multispark config
* remove todo
Co-authored-by: Matthew Kennedy <makenne@microsoft.com>