mirror of https://github.com/rusefi/rusefi-1.git
30 lines
2.0 KiB
Plaintext
30 lines
2.0 KiB
Plaintext
1) RESOLVED IN R0.2 upper mounting hole does not align - see http://rusefi.com/images/Frankenso/frankenso_0_1_back.jpg
|
|
2) RESOLVED IN R0.2 add a jumper to isolate C1002 & C1003 while powered via USB? see http://rusefi.com/forum/viewtopic.php?f=4&t=569&start=50#p9859
|
|
3) RESOLVED IN R0.2 usability issue: GND test pad is under discovery
|
|
4) RESOLVED IN R0.2 add larger +5 test pad?
|
|
5) RESOLVED IN R0.2 add +12 test point?
|
|
6) RESOLVED IN R0.2 Thermocouple needs a via to allow a zip tie to go fully around the connector.
|
|
7) RESOLVED IN R0.2 op-amp reference & part # silkscreen is upside down in relation to the labeling of the actual chips
|
|
8) RESOLVED IN R0.2 Make HIP9011 components into 0805 for common parts
|
|
9) RESOLVED IN R0.2 VDD on STM discovery should be 3V not 5V.
|
|
10) RESOLVED IN R0.2 LCD mounting holes are too small for the Chinese M3 stand-offs
|
|
11) RESOLVED IN R0.2 SD card PB4 should be SO not SI PB5 should be SI not SO.
|
|
12) RESOLVED IN R0.2 USB D- and D+ were on wrong pins, D+ now on USB pin 3, TTL RX and TX were also on the wrong pins
|
|
13) RESOLVED IN R0.2 JP212 is to close to the LCD mounting slot.
|
|
14) separate VP lines of our three hi-side mosfers
|
|
15) RESOLVED IN R0.2 look into flipping the VR + and - pins
|
|
16) add vias for GND, 12V and 5V for test purposes
|
|
17) add option to GND one side of VR in ECU
|
|
18) BOM issue: D1001 should be BZT52C7V5-FDICT-ND?
|
|
19) BOM issue: C1001 sch says 470uF but part number is 100uF?
|
|
20) SKQUCAA010 is End of Life. I've placed and order to get these in October, but we need a better solution
|
|
21) JP212 should be replaced with JP209 which would be breaking the OUT9 line. That's part of hall-via-op-amp circuirty
|
|
|
|
|
|
For honda add-on / rewiring board
|
|
-- Add 2A high side solinoid drive for VTec sol
|
|
-- Add 3rd VR chip for 3rd signal
|
|
-- Add selectable high side drive with +5V or +12V options
|
|
-- re-wire to allow freindly pinout
|
|
|