there is no third trigger simulator channel right?
This commit is contained in:
parent
e8f33ce7ec
commit
3788d6e9f3
|
@ -184,7 +184,7 @@ struct_no_prefix engine_configuration_s
|
|||
#define EGT_CHANNEL_COUNT 8
|
||||
#define DIGIPOT_COUNT 4
|
||||
#define HW_MAX_ADC_INDEX 17
|
||||
#define TRIGGER_SIMULATOR_PIN_COUNT 3
|
||||
#define TRIGGER_SIMULATOR_PIN_COUNT 2
|
||||
#define TRIGGER_INPUT_PIN_COUNT 2
|
||||
#define LOGIC_ANALYZER_CHANNEL_COUNT 4
|
||||
#define SCRIPT_SETTING_COUNT 8
|
||||
|
@ -739,7 +739,9 @@ pin_input_mode_e throttlePedalUpPinMode;
|
|||
float compressionRatio;Just for reference really, not taken into account by any logic at this point;"CR", 1, 0, 0, 300, 1
|
||||
|
||||
Gpio[TRIGGER_SIMULATOR_PIN_COUNT iterate] triggerSimulatorPins;Each rusEFI piece can provide synthetic trigger signal for external ECU. Sometimes these wires are routed back into trigger inputs of the same rusEFI board.\nSee also directSelfStimulation which is different.
|
||||
uint16_t unusedTrig
|
||||
pin_output_mode_e[TRIGGER_SIMULATOR_PIN_COUNT iterate] triggerSimulatorPinModes;
|
||||
uint8_t unusedTrigMode
|
||||
output_pin_e o2heaterPin;Narrow band o2 heater, not used for CJ125. 'ON' if engine is running, 'OFF' if stopped or cranking. See wboHeaterPin
|
||||
pin_output_mode_e o2heaterPinModeTodO;
|
||||
|
||||
|
|
|
@ -2534,7 +2534,6 @@ cmd_set_engine_type_default = "@@TS_IO_TEST_COMMAND_char@@@@ts_command_e_TS_
|
|||
dialog = allPins1_1
|
||||
field = "trigger stimulator pin #1", triggerSimulatorPins1
|
||||
field = "trigger stimulator pin #2", triggerSimulatorPins2
|
||||
field = "trigger stimulator pin #2", triggerSimulatorPins3
|
||||
field = "Warning Led", warningLedPin
|
||||
field = "tle6240_cs", tle6240_cs
|
||||
field = "tle6240 SPI", tle6240spiDevice
|
||||
|
@ -3925,8 +3924,6 @@ dialog = tcuControls, "Transmission Settings"
|
|||
field = "trigger stimulator pin mode #1", triggerSimulatorPinModes1@@if_ts_show_hardware_simulator
|
||||
field = "trigger stimulator pin #2", triggerSimulatorPins2@@if_ts_show_hardware_simulator
|
||||
field = "trigger stimulator pin mode #2", triggerSimulatorPinModes2@@if_ts_show_hardware_simulator
|
||||
field = "trigger stimulator pin #3", triggerSimulatorPins3@@if_ts_show_hardware_simulator
|
||||
field = "trigger stimulator pin mode #3", triggerSimulatorPinModes3@@if_ts_show_hardware_simulator
|
||||
field = ""
|
||||
field = "Logic input channel 1", logicAnalyzerPins1
|
||||
field = "Logic input channel 2", logicAnalyzerPins2
|
||||
|
|
Loading…
Reference in New Issue