* dead fast tps
* oooooh map avg on hh7
* adc v4 fast support
* new fast API
* hardware.cpp
* adc v2
* warning
* guard
* no check required
* stub cypress/kinetis
* kinetis and cypress stubs
* fix for stepperHbridgeHardware
* new config fields for microstepping
* add stepper dir pin mode to the dialog
* refactor stepper hw dialog & add microstepping panel
* microstepper modes enum
* stepperDcInvertedPins needed by Hellen
* add sleep() for stepper and divisor for pause()
* microstepping impl.
* make unit-tests more happy
* small progress
* fix etb-stepper dlg conflict
Co-authored-by: Andrei <andreikagit@users.noreply.github.com>
* more unification
* hip stub
* comment
* guard
* channel idx
* include
* hip
* move in to engine
* hip9011
* dead stuff
* dead
* fsio
* lcd
* more dead
* d
* dead code
* all your ram are belong to me
* turn off gpiochips we don't need
* save
* save by using the same file handle
* smaller stack ok
* these can be on the stack
* this is closer
* what about ccm?
* probing available
* now probe ccm
* ccm
* put stuff in ccm
* fsio
* memory usage
* memory
* allow re-register of the same sensor
* add api to unsubscribe
* do it for tps
* clear the pin
* happy test
* maybe make afr happy for now
* tests build
* happy simulator
* active configuration
* check valid
* we need vbatt now
* manage all pin init in init_sensors.cpp
* don't need that
* cleanup
* thermistors
* do two phase reinit in the right place
* config vs engine
* finally the tests are happy
* Typo fix
* flash_main: always allow to write settings to ext NOR while running
* mc33810: do not enable outputs right after undervoltage
Wait for next active signal
* QSPI flash: set correct dummy cycles for fast read command
* board subaru: fix connector pinout. again.
* board subaru: fix SDMMC pin configuration
* board subaru: fix DMA conflict SPI4_RX vs SDMMC2
* flash_main.cpp: reorder code for easy integration of ext storage
* Add EFI_STORAGE_INT_FLASH option
Default set to TRUE
* Add ChibiOS's Managed Flash Storage to build
* Add support for QSPI flash (SST26F064A tested)
* board: subaru: enable WSPI and NOR flash drivers
* Add option to save settings on ext flash MFS partition
* board: subaru: store settings on QSPI NOR flash
* big pch energy
* put back ramdisk stub
* tests are happy
* h743 nucleo
* kinetis
* I love deleting code!
* make stepper happy
Co-authored-by: Matthew Kennedy <makenne@microsoft.com>
* perform extra-step-prevention in the stepper driver itself
* isBusy flag
* I am unable to type
* the court of public opinion has decided that greater-equal is correct
* that sets target in steps, not percent
* correct var name
* mock stepper motor
* testable stepper
* build is happy
* helping build
* STM32F7xx: flash write parallelism settings
Datasheed allows 32bit program operation only for 2.7..3.0
While RM defines wider range...
* Add parentheses to defines
* intFlash: show all errors to user
Currently only erase error was exported to user. Flash write error
was silent. Also define few additional error codes and show it to
user.
Matthew Kennedy
Andreika
rusefillc
Andrey
alxrMironov
Andrey G