23 lines
2.4 KiB
Plaintext
23 lines
2.4 KiB
Plaintext
1) RESOLVED IN R0.2 Move C26, it's currently under an inductor. 2 parts can not sit in the same physical space
|
|
2) RESOLVED IN R0.2 Add via for battery wire to be attached.
|
|
3) RESOLVED IN R0.2 L1 wire leads interfere with C14 and C15.
|
|
4) RESOLVED IN R0.2 Jumpers are not needed. Connect VccIO->VccIO_Ext and Clk->Y1-3
|
|
5) RESOLVED IN R0.2 D9 had wrong footprint blah. Wrong pin numbers to wrong pins.
|
|
6) RESOLVED IN R0.2 D10 --> D10_2, and D11 --> D11_2 should be the same package, they were 2 different / wrong footprints.
|
|
7) RESOLVED IN R0.3 Moved several 0805 components to the back side of the PCB for lower cost assembly.
|
|
8) RESOLVED IN R0.3.2 J15 needs silk and larger hole. J20 needs silk and should use same larger terminal as J8-J9-J10
|
|
9) RESOLVED IN R0.3.2 J15 & J20 silk ^^^ should be on both top and bottom sides of the board
|
|
10) See 14 power LED. back side is pretty much free pre-assembled, front side is manual assembly. maybe one LED on each side?
|
|
11) RESOLVED IN R0.3.2 J5&J6 why do we need as jumpers? Shall we connect those permanently since looks like those shall be connected?
|
|
12) See 14 move more small stuff to same (back) side
|
|
13) RESOLVED IN R0.3.2 Fix courtyard warnings on back side, move components slightly.
|
|
14) RESOLVED IN R0.3.2 The current board layout is very hard to work with - can we please have all components on top? PCB space cost nothing comparing with the stress of flipping and poking
|
|
15) RESOLVED IN R0.3.2 Noxz is asking to move C21 to next to C22
|
|
16) RESOLVED IN R0.3.2 terminals usability is asking for improvements. Ideally can we move more terminals to the edge of the board? ADDED TP2, TP3, TP4, TP5, TP7, TP7, and TP8
|
|
17) RESOLVED IN R0.3.2 Add many LED's for easier diagnostics like PT2000 board.
|
|
18) RESOLVED IN R0.3.3 Update BoostV indicator LED per https://rusefi.com/forum/viewtopic.php?f=4&t=1337&start=75
|
|
19) RESOLVED IN R0.3.3 Can we connect connect TP6 to VCCIO since both are 3v?
|
|
20) RESOLVED IN R0.3.3 silkscreen font should be larger for DRIVER RSTB etc https://raw.githubusercontent.com/wiki/rusefi/rusefi/Hardware/MC33816_test_board/MC33816_test_board_3_2_assembled.jpg
|
|
21) RESOLVED IN R0.3.3 silkscreen for FLAG0 etc is covered by header plastic https://raw.githubusercontent.com/wiki/rusefi/rusefi/Hardware/MC33816_test_board/MC33816_test_board_3_2_assembled.jpg
|
|
22) RESOLVED IN R0.3.3 move TP7=GND to a safer location on the edge of the PCB
|
|
23) |