15 lines
1.3 KiB
Plaintext
15 lines
1.3 KiB
Plaintext
1) RESOLVED IN R0.2 SOIC24 wrong size
|
|
2) RESOLVED IN R0.2 Q1 MOSFET is not connected properly.
|
|
3) RESOLVED IN R0.3 DIAHD silkscreen on pad #6 should be DIAHG
|
|
4) RESOLVED IN R0.3 add a note describing UR (R8) and UA (R15) low pass filter / slew rate limiter
|
|
5) RESOLVED IN R0.3 Correct C9 should match C2 for 1kHz low pass filter.
|
|
6) RESOLVED IN R0.3 R12 is not routed right
|
|
7) RESOLVED IN R0.3 voltage divider on UR and UA channels, 5V --> 3V (not clear if we need this on the little board - we can always use external divider)
|
|
8) RESOLVED IN R0.3 R3 is now 0R and C3 is now DNP. These are here incase a filter is needed, as shown in some of the OEM's documentation.
|
|
9) enlarge silkscreen font - current font is too small
|
|
10) match Frankenso GND/3v/5v pinout
|
|
11) RESOLVED IN R0.3 provide 4 extra holes in corners just for flat mounting
|
|
12) RESOLVED IN R0.3 power ON status LED, heater intensity LED
|
|
13) RESOLVED IN R0.4 Change solder mask, from 0.007874015748 to 0.003.
|
|
14) RESOLVED IN R0.4.1 Change LSU4.9 to 301 ohms, as noted here https://rusefi.com/forum/viewtopic.php?f=4&t=1052&start=143
|
|
15) RESOLVED IN R0.4.1 Change Rfb1 and Rfb2 should be increased to 5.11k and 511k as noted here https://rusefi.com/forum/viewtopic.php?f=4&t=1052&start=143 |