K

firmware/config/boards/hellen/hellen-honda-k/board_configuration.cpp

@@ -110,12 +110,14 @@ void setBoardDefaultConfiguration() {
 	engineConfiguration->canRxPin = H176_CAN_RX;
 
 	engineConfiguration->fuelPumpPin = H144_OUT_IO9;
-//	engineConfiguration->idle.solenoidPin = Gpio::D14;	// OUT_PWM5
-//	engineConfiguration->fanPin = Gpio::D12;	// OUT_PWM8
+	engineConfiguration->idle.solenoidPin = H144_LS_6;
+	engineConfiguration->fanPin = H144_OUT_IO12;
 	engineConfiguration->mainRelayPin = H144_OUT_IO3;
 	engineConfiguration->malfunctionIndicatorPin = H144_OUT_IO7;
 
 	engineConfiguration->brakePedalPin = H144_IN_CAM;
+	engineConfiguration->acRelayPin = H144_LS_5;
+//    engineConfiguration->tachOutputPin = ;
 //	engineConfiguration->acSwitch = H144_IN_RES1;
 
 	// "required" hardware is done - set some reasonable defaults

firmware/config/boards/hellen/hellen-honda-k/connectors/main.yaml

@@ -34,9 +34,14 @@ pins:
   - pin: A11
     function: Analog GND
     type: gnda
+
   - pin: A12
+    # H144_LS_6
+    id: F12
+    class: outputs
     ts_name: A12 Idle Air Control
     function: Idle Air Control Valve
+
   - pin: A13
     ts_name: --- - EGR
     function: EGR
@@ -300,6 +305,15 @@ pins:
     ts_name: --- - STEERING PRESSURE SW
     function: Steering Pressure Switch
 
+  - pin: E18
+# H144_LS_5
+    id: D9
+    class: outputs
+    ts_name: ___ - AC Relay
+    function: A/C Relay
+    type: ls
+
+
   - pin: E20
     ts_name: --- - EVAP
     function: EVAP