diff --git a/Cranking.md b/Cranking.md
index 30efb057..eed36936 100644
--- a/Cranking.md
+++ b/Cranking.md
@@ -69,7 +69,6 @@ rusEFI has a separate cranking control strategy for your first couple of engine
## General Cranking Settings
### Cranking RPM limit
*This sets the RPM limit below which the ECU will use cranking fuel and ignition logic, typically this is around 350-450 rpm.* More...
-In rusEFI Console, you can use command ```set cranking_rpm X``` to change this value.
### Enable cylinder cleanup
*When enabled, if the throttle pedal is held above 90% then no fuel is injected while cranking to clear excess fuel from the cylinders.*
@@ -92,9 +91,6 @@ In rusEFI Console, you can use command ```set cranking_rpm X``` to change this v
See also isFasterEngineSpinUpEnabled
-rusEFI Console command:
-```set cranking_priming_pulse X```
-
### Falloff temperature
@@ -125,16 +121,12 @@ rusEFI Console command:
More...
-To adjust cranking fuel, use ```set cranking_fuel XXX``` command, where XXX is the number of total fuel squirt duration in milliseconds. See also [Console Commands - Fuel Control](Dev-Console-Commands#fuel-control)
-
## Ignition Settings
### Advance
*Ignition advance angle used during engine cranking, 5-10 degrees will work as a base setting for most engines.*
-*rusEFI Console command:
-```set cranking_timing_angle X```*
### Use separate Advance Table for cranking
@@ -150,8 +142,6 @@ To adjust cranking fuel, use ```set cranking_fuel XXX``` command, where XXX is t
*If set to true, will use the specified duration for cranking dwell. If set to false, will use the specified dwell angle. Unless you have a really good reason to, leave this set to true to use duration mode.*
-*rusEFI Console command:
-```set cranking_charge_angle X```*
## IAC Settings
### Cranking IAC position