From 79fc17107cd4ec99cea0688b5f822819426c941a Mon Sep 17 00:00:00 2001 From: stefanst Date: Wed, 9 Sep 2020 15:10:56 -0400 Subject: [PATCH] Updated Miata NA 48 pin board for MRE (version 0.2) (markdown) --- Miata-NA-48-pin-board-for-MRE-(version-0.2).md | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/Miata-NA-48-pin-board-for-MRE-(version-0.2).md b/Miata-NA-48-pin-board-for-MRE-(version-0.2).md index f5659e1b..30d140a6 100644 --- a/Miata-NA-48-pin-board-for-MRE-(version-0.2).md +++ b/Miata-NA-48-pin-board-for-MRE-(version-0.2).md @@ -39,7 +39,7 @@ Alternatively, you can wire a standard USB cable into the main connector for a m The board comes with an adapter for a Micro SD card. Install a card in this slot and it will automatically keep a log of your engine when it's running. Please note that the only way to retrieve this log at this point (July 2nd 2020) is to open the case, remove the SD card and read it directly from a computer or other device running MegaLogViewer. The ability to read and manipulate logs without removal, via USB is planned, but not yet implemented. ![Micro SD adapter](Hardware/pnp_microRusEfi_48na/Micro_SD_adapter.png) -Warning: There are reports that some Micro SD cards will not work for this setup. So if you are having trouble with this, +Warning: There are reports that some Micro SD cards will not work for this setup. So if you are having trouble with this, try a different card. ## 2.3. MAP Sensor Your board may, or may not, have an onboard MAP sensor. The onboard MAP sensor can either be used as a primary MAP sensor to supply the ECU with a load signal, or it can be used for barometric correction for units running an external MAP sensor. In order to use the internal MAP sensor to supply the ECU load signal you have to run a 3/16" (5mm) vacuum hose from the intake manifold to the unit and drill a hole in the stock ECU case. (see picture below).