# rusEFI PCB Configurations

When ordering rusEFI the ECU boards may be bought in several different stages of assembly completeness. These stages may range from the bare board with no components attached all the way to fully assembled PCBs already in enclosures. What should be ordered by the end user is up to them, their soldering skills and capabilities, and how much they value their time.

1. **Bare PCB**: No components soldered. For the end user, soldering would be required for **ALL** components.  
![BareMRE](Hardware/Images/BareMRE.png "Bare MRE")

2. **Partially Populated Board**: More than a half of components soldered to it. This board would require the end user to do some SMT and/or through-hole soldering to get a functional board.  
![PartialMRE](Hardware/Images/PartialMRE.png "Partial MRE")

3. **Fully Populated Board**: No soldering is required by the end user to have a fully functional board but a case is not included.  
![PopulatedMRE](Hardware/Images/PopulatedMRE.png "Populated MRE")

4. **Fully Assembled**: All SMT and through hole devices are populated and the board is in a case. The end user does not need to open the case or ever look at the PCB. As far as the end user is concerned the product just needs to be wired in.  
![CompleteMRE](Hardware/Images/CompleteMRE.png "Complete MRE")

## Options

1. **PnP (plug & play)**: If the board is designed to be plug and play, plugged into the OEM harness and operate properly.
2. **Add Connector**: If the board is sold with the harness side connectors required.
3. **Add Pigtail**: If the board is sold with the harness side connectors required and there are wires in the harness side connectors.
4. **Add Harness**: If the board is sold with a vehicle specific harness so that the ECU needs to be connected to the vehicle with the harness and the engine will start.