Initial creation of repo

kartduino.ino

@@ -0,0 +1,47 @@
+
+//**************************************************************************************************
+// Config section
+//this section is where all the user set stuff is. This will eventually be replaced by a config file
+
+/*
+Need to calculate the req_fuel figure here, preferably in pre-processor macro
+*/
+#define engineCapacity 100 // In cc
+#define engineCylinders 1 // May support more than 1 cyl later. Always will assume 1 injector per cylinder. 
+#define engineInjectorSize 100 // In cc/min
+#define engineStoich 14.7 // Stoichiometric ratio of fuel used
+//**************************************************************************************************
+
+int req_fuel = ((engineCapacity / engineInjectorSize) / engineCylinders / engineStoich) * 100; // This doesn't seem quite correct, but I can't find why. 
+
+// Setup section
+int triggerPin = 5;
+int triggerTeeth = 12;
+int triggerMissingTeeth = 1;
+int triggerOffset = 120;
+
+
+
+void setup() {
+  int thisPin;
+  // the array elements are numbered from 0 to (pinCount - 1).
+  // use a for loop to initialize each pin as an output:
+  for (int thisPin = 0; thisPin < pinCount; thisPin++)  {
+    pinMode(ledPins[thisPin], OUTPUT);      
+  }
+  
+  
+}
+
+void loop() {
+  // loop from the lowest pin to the highest:
+  for (int thisPin = 0; thisPin < pinCount; thisPin++) { 
+    // turn the pin on:
+    digitalWrite(ledPins[thisPin], HIGH);   
+    delay(timer);                  
+    // turn the pin off:
+    digitalWrite(ledPins[thisPin], LOW);    
+
+  }
+  
+