From f1ac66c1be6532579d0fb0f8a0b94ab7966288b5 Mon Sep 17 00:00:00 2001 From: Anthony Long Date: Tue, 2 Feb 2021 09:40:20 +0000 Subject: [PATCH] docs: update configuration/Trigger_Setup --- configuration/Trigger_Setup.md | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/configuration/Trigger_Setup.md b/configuration/Trigger_Setup.md index d35da84..dbf6535 100644 --- a/configuration/Trigger_Setup.md +++ b/configuration/Trigger_Setup.md @@ -2,7 +2,7 @@ title: Trigger Setup description: Setting up the RPM trigger input to work correctly with the Speeduino decoder published: true -date: 2021-01-31T04:34:51.789Z +date: 2021-02-02T09:40:10.770Z tags: editor: markdown dateCreated: 2020-01-06T01:54:10.355Z @@ -27,7 +27,7 @@ Note that many of the settings on this dialog are dependant on your configuratio - **Missing teeth** - If using the missing tooth pattern, this is the size of the gap, given in 'missing teeth'. Eg 36-1 has 1 missing tooth. 60-2 has 2 missing teeth etc. The missing teeth **MUST** be all located in a single block, there cannot be multiple missing tooth gaps around the wheel. - **Secondary teeth** - As above, but for the secondary input. This input is always assumed to run at cam speed. - **Trigger angle multiplier** - This option is used only on the [Non-360 pattern](/decoders/non-360). -- **Trigger angle** - The angle of the crank, **After Top Dead Centre (ATDC)**, when tooth \#1 passes the sensor on the primary (crank) input. This setting is critical for Speeduino to accurately know the current crank angle. See section below ('Finding tooth \#1 and trigger angle') for further information on how to determine this value +- **Trigger angle** - The angle of the crank, **After Top Dead Centre (ATDC)**, when tooth \#1 passes the sensor on the primary (crank) input. This setting is critical for Speeduino to accurately know the current crank angle. See section below ('Finding tooth \#1 and trigger angle') for further information on how to determine this value. You should be using a timing light to confirm angle is correct once calculated. Without doing this your angle may be incorrect. ### Trigger options