mirror of https://github.com/FOME-Tech/fome-fw.git
fc17c63d51
* Typo fix * flash_main: always allow to write settings to ext NOR while running * mc33810: do not enable outputs right after undervoltage Wait for next active signal * QSPI flash: set correct dummy cycles for fast read command * board subaru: fix connector pinout. again. * board subaru: fix SDMMC pin configuration * board subaru: fix DMA conflict SPI4_RX vs SDMMC2 |
||
---|---|---|
.. | ||
adc | ||
algo | ||
digital_input | ||
drivers | ||
mass_storage | ||
mc33816 | ||
microsecond_timer | ||
ports | ||
sensors | ||
backup_ram.h | ||
cdm_ion_sense.cpp | ||
cdm_ion_sense.h | ||
debounce.cpp | ||
debounce.h | ||
flash_int.h | ||
hardware.cpp | ||
hardware.h | ||
hip9011.md | ||
hw_layer.mk | ||
io_pins.cpp | ||
io_pins.h | ||
mc33816.cpp | ||
mc33816.h | ||
mc33816_data.c | ||
mc33816_data.h | ||
mc33816_memory_map.h | ||
mmc_card.cpp | ||
mmc_card.h | ||
pin_repository.cpp | ||
pin_repository.h | ||
readme.md | ||
rtc_helper.cpp | ||
rtc_helper.h | ||
servo.cpp | ||
servo.h | ||
smart_gpio.cpp | ||
smart_gpio.h | ||
stepper.cpp | ||
stepper.h | ||
stepper_dual_hbridge.cpp | ||
trigger_input_adc.cpp | ||
vehicle_speed.cpp | ||
vehicle_speed.h |