39 lines
1.7 KiB
Markdown
39 lines
1.7 KiB
Markdown
## Software (Python script) to control the EPROM emulator
|
|
|
|
### Currently recommended firmware and software:
|
|
* Firmware 2.0rc4 (EPROM_EMU_NG_FW_2.0rc4.ino - Arduino sketch in [Firmware](https://github.com/Kris-Sekula/EPROM-EMU-NG/tree/master/Firmware) folder)
|
|
* Software 2.0rc3 (EPROM_NG_v2.0rc3.py - Python script)
|
|
|
|
### If you want to try new features (increased speed of transfer, support for EEPROM) use the following:
|
|
* Firmware 2.0rc12 (EPROM_EMU_NG_FW_2.0rc12.ino - Arduino sketch in [Firmware](https://github.com/Kris-Sekula/EPROM-EMU-NG/tree/master/Firmware) folder)
|
|
* Software 2.0rc9 (EPROM_EMU_NG_2.0rc9.py - Python script)
|
|
|
|
Python script to control the EPROM EMULATOR NG.
|
|
|
|
The emulator will show up as a serial port on your computer, depending on your the OS type and version you may need to install drivers, follow this instructions:
|
|
|
|
https://learn.sparkfun.com/tutorials/how-to-install-ch340-drivers/all
|
|
|
|
Requires python 3.8, and the following libraries:
|
|
* pySerial (install by running the following commnad on your computer ```pip install pyserial```)
|
|
* pySimpleGui (```pip install pysimplegui```) 4.30.0 or above
|
|
|
|
parameters like type of memory, hex file etc should be provided via command line.
|
|
|
|
For **GUI mode**, just run the script **without parameters** and GUI will show up (of course only works in GUI environments :))
|
|
|
|
Example of parameters and output:
|
|
```
|
|
#python.exe EPROM_NG_v1.5h.py -mem 27256 -spi y -auto n 27256.HEX com4
|
|
Running EPROM EMU NG python script version 1.5h
|
|
|
|
Using serial port COM4, emulating: 27512 EPROM
|
|
|
|
-- attempting to get sync --
|
|
|
|
-> HW: 1.4 @ 115200, FW: 1.6, SPI: 0, Auto: 0, Last EPROM: 6, mygeekyhobby.com 2020 :)
|
|
|
|
-- prcessing file --
|
|
-> Emulator Running.
|
|
```
|