* fix building for STM32F401CC and general macro cleanup
* Now building for all generic STM32F4x7 boards in arduino IDE is ok.
* buildflag cleanup
Co-authored-by: Tjeerd <tjeerdie@users.noreply.github.com>
* Fix building for FRAM with globals.h setting
On request of vitor boss. A lot has been changed around to make the selection of EEPROM emulation type from the globals.h (including FRAM selection)
* Add support for EEPROM emulation on internal flash of STM32F7
* Updates on SPI Flash EEPROM
* Fix building for BACKUPSRAM as EEPROM.
* Add put() and get() functions to the EEPROM emulation. This is needed for the latest terminstor and other calibrations routines
Co-authored-by: Tjeerd <tjeerdie@users.noreply.github.com>
* Added new Flash EEPROM emulation
# Conflicts:
# platformio.ini
# speeduino/board_stm32_official.ino
# speeduino/init.ino
# speeduino/src/SPIAsEEPROM/SPIAsEEPROM.cpp
# speeduino/src/SPIAsEEPROM/SPIAsEEPROM.h
* changes to storage to make SPI flash work again
* cleanup
* fix building with spi flash as config storage
* Fixing build with spi flash as EEPROM. Changed some pin numbers to match the board i am designing and testing now.
* Now cs pin for spi eeprom is settable by flag in build enviroment.
* Correct overflow for 32bit timers
* fix pins PA0-PA5 on some f407 boards
* Enable access to SRAM Backup domain at boot
* Add missing callback functions
* Change timer resolutions. Corrects idle/aux timer frequencies
* 32 bit overflow only for STM32F4
* Update platformio.ini
debug tool added as default
* fix building with spi flash as config storage
* Fixing build with spi flash as EEPROM. Changed some pin numbers to match the board i am designing and testing now.
* Now cs pin for spi eeprom is settable by flag in build enviroment.
* Update platformio.ini
debug tool added as default
* Update cancomms.ino
Removed CAN build on black_F407VE for now. It needs fixing the build fails otherwise.
Co-authored-by: hoogendijkta <tjeerdie@users.noreply.github.com>
Co-authored-by: iLeeeZi <ilari.vehniainen@hotmail.fi>
* fix to serial0 and serial3 when offset is 0 uses wrong command
* fix to serial0 and serial3 when offset is 0 uses wrong command
* fix hex num
* add teensy canbus library
teensy can read and write functions enabled
* update to teensyduino 1.49
* part 1 prepare structure for obd can port works
rename old can_command() to secondarySerial_command() for secondary serial and create new can_command for real CAN instruction decode.
fix masking for teensy 3x and 4
* set mega as default build
Co-authored-by: Josh Stewart <josh@noisymime.org>
add temp test file to gitignore
improve schedule testing
add check for schedule delays and pending variants
move time sampling to callback methods
add comments and improve pending tests
Josh Stewart
Tjeerd
Vitor Moreno B. Sales
Autohome2
Bruno Bousquet
hoogendijkta