* Make idle advance respect delay
Also increased resolution to half second.
Remove code duplication, removed unnecessary math
* Add a new configurable delay
* Fix copy paste error
Co-authored-by: Josh Stewart <josh@noisymime.org>
* Add missing commas
* Missing closing brace
* Missing &
Was using bitwise comparison (&): looks like it should be boolean (&&)
* Remove extra closing brace "}"
Co-authored-by: Josh Stewart <josh@noisymime.org>
* Enhanced programmable outputs
Added possibility to set minimum programmable output time.
Added names for the comparators to make it more user friendly, TS will complain about the change for existing tune.
Added more possibilities
Added possibility to set a minimum or a maximum output time
Added possibility to combine any number of rules or all of them
I got a lot of requests for this feature.
Keeps the RAM usage the same.
fix
* Fixed maximum timing
* Fix STM32 build
* Add RPM switch point for instantaneous MAP reading
* Add descriptions and other stuff to make PR
* Add suggested changes
* Use RPMdiv 100 for reading switch point
Co-authored-by: Josh Stewart <josh@noisymime.org>
* Pin mapping for BMW PnP boards
BMW PnP pin mapping to support 6cyl fully seqvential. Basically same as v0.4 pin mapping, but in addition there is correct pins for ign/inj 5-6.
* F407 pinout
Not finished
* Added VSSpin to the pin definition
* Added also missing baro sensor pin
* F407 pinout to match my MEGA replacement board
* Fix small typo
* STM32F407 pinout
Co-authored-by: Pasi Kemppainen <pazi88@users.noreply.github.com>
* Boost by Gear
* Minor changes to PR
- Changed *2 into bitwise operator
- Reserved 1 extra bit for boostByGearEnabled for 2 additional boost by gear modes in the future
* Added mode to set percentage of boost target table
* added status values to CANcom
I added the missing status value to CANcomms to be able to acces them via serial.
* Revert "added status values to CANcom"
This reverts commit 2d0abb9f36.
* added status values to CANcomms
added values to CANcomms to be able to acces them via serial
* corrected the number of values
* fixed the packet size
* change order and some values
I removed some status and added some
* comments and remove double
remove some status that where there two times and added comments for status1, 2, 3, 4