2 failure modes added:
* On boot, when calculating DC offsets generate a fault if the offset is beyond
HW_MAX_CURRENT_OFFSET. Fault code reports which sensor is having issues (1, 2 or 3).
Most likely cause is a disconnected sensor, if hw has fault-detecting pullups.
* On runtime, in setups with 3 in-line phase current sensors, checks that the sum
of the currents is below MCCONF_MAX_CURRENT_UNBALANCE, with a configurable low pass
filter. If unbalanced current is high, it means a fault to ground, or a disconnected
sensor (this works at 0 Amp if hw has pullups in the sensor input to detect the
failure).
Signed-off-by: Marcos Chaparro <mchaparro@powerdesigns.ca>
This commit adds a motor model running within the vesc firmware,and
from the vesc terminal a user or a test script can set the
mechanical load torque, inertia, phase resistance, Lq and Ld phase
inductances (this generic model includes IPM motors), flux linkage
and battery voltage.
Virtual motor parameters set at the command line should match with
vesc configuration, for example phase resistance, inductance and
flux linkage should match and have the correct observer gain.
Observer works with the virtual motor, with some hiccups during
startup
For solid results its better to use sensored mode. If vesc is
configured to use an SPI encoder the virtual motor phase angle
will be injected as an encoder angle readout.
For safety PWM outputs are disabled during simulation.
Signed-off-by: Maximiliano Cordoba <mcordoba@powerdesigns.ca>
Marcos Chaparro
Maximiliano Cordoba
Benjamin Vedder