2017-01-30 20:05:07 -08:00
1) RESOLVED IN R0.2 SOIC24 wrong size
2) RESOLVED IN R0.2 Q1 MOSFET is not connected properly.
3) RESOLVED IN R0.3 DIAHD silkscreen on pad #6 should be DIAHG
4) RESOLVED IN R0.3 add a note describing UR (R8) and UA (R15) low pass filter / slew rate limiter
5) RESOLVED IN R0.3 Correct C9 should match C2 for 1kHz low pass filter.
2017-02-03 20:04:50 -08:00
6) RESOLVED IN R0.3 R12 is not routed right
2018-02-04 11:41:44 -08:00
7) RESOLVED IN R0.3 voltage divider on UR and UA channels, 5V --> 3V (not clear if we need this on the little board - we can always use external divider)
2018-01-29 18:41:32 -08:00
8) RESOLVED IN R0.3 R3 is now 0R and C3 is now DNP. These are here incase a filter is needed, as shown in some of the OEM's documentation.
9) enlarge silkscreen font - current font is too small
2018-02-04 11:41:44 -08:00
10) match Frankenso GND/3v/5v pinout
2018-02-04 17:35:34 -08:00
11) RESOLVED IN R0.3 provide 4 extra holes in corners just for flat mounting
2018-06-30 09:03:44 -07:00
12) RESOLVED IN R0.3 power ON status LED, heater intensity LED
13) RESOLVED IN R0.4 Change solder mask, from 0.007874015748 to 0.003.
