CAN moved from PA11, PA12 to PB8, PB9
PA11, PA12 used as USB
DISP4,5,6 moved to PB13,14,15
LED_GREEN is moved to PB7
5V and GND signals are added to connector (around UART and USB)
can be used in both directions:
- power device on table
- power some ext devices
!!!!!PCB and Gerber were not updated!!!!!
-add C for input RC filter
-add 2.7 pull-up to 5V on IN1, IN2 (optional for SENT)
-move Input_1..Input_4 to PC6..PC9 that are capable for input
capture with TIM3/TIM8
-LED_GREEN moved from PC9 to PC10
!!!!!PCB and Gerber was not updated!!!!!
* Fix LCSC for few components
* Update path to 3D models (due to KiCAD6)
* Exclude debug connectors, testpoints from BOM and position file
Also do not show them on 3D view
* Wideband Rev 2
* Remove old version (now KiCAD 6 is used)
Files extension now have kicad_ prefix
* Adjust RefDefs on schematic
* Silkscreen instruction about CANID
* No thermal reliefs under LDO
* Mooooore vias to God of vias
* F103: Rev 2: updates
Added testpoints to unused MCU pins (where possible)
Added LSU_ADV AC injection R
Bias current resistor (LSU4.9) is now controlled by gpio
Added Heater- sense. To check is sensor present/heater problems.
Minor fixes
* Final cleanups
* Update gerbers, drill, BOM
* Update BOM: correct 27K to 30K JLCPCB ID
* f103: pcb: gerber export settings
* f103: sch and pcb: update component values, JLC BCP refs
* Compress gerbers and move to rev2 directory
* Move position files out of zip
* No need in bottom position file
* Rev2: readme
* Update board for available components
* Add fuseholder pattern
rusefillc
mi-hol
Nadezhda-n
Andrey G
Nadezhda
rusefillc
Denis
rusefi
Dave Blundell