1.3 KiB
1.3 KiB
NOTE: This is currently under development. This page might be wrong or change quickly.
Pinout
| Pin Number | Function | Notes |
|---|---|---|
| 1 | Ground | Connect to chassis ground |
| 2 | LSU Ip | Connect to sensor pin |
| 3 | LSU Heater - | Connect to sensor pin |
| 4 | LSU Heater + | Connect to sensor pin |
| 5 | No connection | |
| 6 | 12v Supply | Connect to fuel pump supply or independent relay controlled by ECU |
| 7 | No connection | |
| 8 | LSU Vm | Connect to sensor pin |
| 9 | LSU Rtrim | Connect to sensor pin |
| 10 | LSU Un | Connect to sensor pin |
| 11 | CAN H | CAN bus high |
| 12 | CAN L | CAN bus low |
LED decoding
| Blue LED | Green LED | Meaning |
|---|---|---|
| off | fast flash | sensor warming up |
| off | slow flash | Sensor hot, operating normally |
| flashing | off | See error code table below |
| alternating | alternating | Bootloader |
Error Codes
Green LED off and blue LED flashing indicates an error. The blue LED will blink a certain number of times, with a 2 second pause, then repeats.
| Blinks | Meaning |
|---|---|
| 3 | Sensor failed to heat up within 15 seconds |
| 4 | Sensor overheated after entering closed loop mode |
| 5 | Sensor unexpectedly cold after entering closed loop mode (bad wiring?) |