wiki.js/configuration/Programmable_Outputs.md

title	description	published	date	tags	editor	dateCreated
Programmable Outputs		true	2022-04-04T08:51:25.574Z		markdown	2022-04-04T08:51:25.574Z

Programmable Outputs

Overview

Speeduino features 8 programmable (on/off) outputs that can be used for purposes that can't be done with regular functionalities on Speeduino firmware. Using of these programmable outputs usually requires creating custom circuitry on the speeduino board to convert logic level arduino pins to drive actual hardware on the engine. Although some boards might have spare outputs that can be used.

Programmable Outputs dialog

{.align-center width=400}

• Select Rule number - The programmable output number (1-8)
• Output Pin Num - Sets the output pin. Note that this is Arduino pin number. Not IDC or other ECU connector pin number
• Rule Alias - This can be used to rename the output based on what it is controlling.
• Output Polarity - Sets if the output pin goes low or high when output is active. Active low means that output gets grounded when it's active and Active high means that output goes to 5v when active.
• Activation Delay(S) - Sets how long the rule conditions need to be met before the output is activated.
• 2nd Condition - The output can have 1 or 2 conditions to be met for it to activate. Set this to Disabled if only one condition is enough. If this is set to And, both conditions need to be met for the output to activate. When Or is selected, it's enough that only one of the conditions is met for the output to activate. Third option is XOR which activates the output if one of the conditions are met. If both or none of the conditions are met, output stays off.
• Condition 1/2 - To set what actually activates the output. For example if you want the output to activate when MAP value is higher than 80kPa, select MAP (kPa) on the left drop down. Then > (greater) for the right dropdown and lastly set the value to 80. This makes output activate above 80kPa MAP value.
• Limit time active - This can be used to limit how long the output is active. Limiting can be used for how long the output must be on by minimum or how long it can be on at maximum. Setting this to 0.0 makes the output to be active whenever conditions are met.