mirror of https://github.com/speeduino/wiki.js.git
3.3 KiB
3.3 KiB
title | description | published | date | tags |
---|---|---|---|---|
Engine Constants | true | 2020-01-16T11:35:42.148Z | TunerStudio |
Overview
From the Settings menu, select Constants
Here you need to setup the engine constants. Fill out the fields in the bottom section before calculating the Required Fuel.
Settings Description
- Control Algorithm: The load source that will be used for the fuel table
- Squirts per Engine Cycle: How many squirts will be performed over the duration of the engine cycle (Eg 720 degrees for a 4 stroke). most engines will not require values greater than 4. For sequential installations, this should be set to 2 with the injector staging set to 'Alternating'(Internally Speeduino will adjust the squirts to 1)
- Note that for 3 and 5 squirts, you must have a cam signal in addition to the crank.
- Injector Staging: This configures the timing strategy used for the injectors
- Alternating (Recommended for most installs) - Injectors are timed around each cylinders TDC. The exact closing angle can be specific in the Injector Characteristics dialog.
- Simultaneous - All injectors are fired together, based on the TDC of cylinder 1.
- Engine stroke: Whether the engine is 2 stroke or 4 stroke
- Number of cylinders: Number of cylinders in the engine. For rotary engines, select 4.
- Injector Port Type: Option isn't used by firmware. Selection currently does not matter
- Number of injectors: Usually the same as number of cylinders (For port injection)
- Engine Type: Whether the crank angle between firings is the same for all cylinders. If using an Odd fire engine (Eg Some V-Twins and Buick V6s), the angle for each output channel must be specific.
- Injector Layout: Specifies how the injectors are wired in
- Paired: 2 injectors are wired to each channel. The number of channels used is therefore equal to half the number of cylinders.
- Semi-Sequential: Semi-sequential: Same as paired except that injector channels are mirrored (1&4, 2&3) meaning the number of outputs used are equal to the number of cylinders. Only valid for 4 cylinders or less.
- Sequential: 1 injector per output and outputs used equals the number of cylinders. Injection is timed over full cycle. Only available for engines with 4 or fewer cylinders.
- Board Layout: Specifies the input/output pin layout based on which Speeduino board you're using. For specific details of these pin mappings, see the utils.ino file
- MAP Sample Method: How the MAP sensor readings will be processed:
- Instantaneous: Every reading is used as it is taken. Makes for a highly fluctuating signal, but can be useful for testing
- Cycle Average: The average sensor reading across 720 crank degrees is used. This is of Event average are the recommended options for 4 of more cylinders
- Cycle Minimum: The lowest value detected across 720 degrees is used. This is the recommended method for less than 4 cylinders or ITBs
- Event Average: Similar to Cycle Average, however performs the averaging once per ignition event rather than once per cycle. Generally offers faster response with a similar level of accuracy.