-Fix D term to use angle rather than error (which includes tilt steps)
-Switch TT to Biquad (Clear z1 z2)
-Split TT Relax speed
-Add Biquad to D term
-Add console command to graph specific variables
-Add console command to dump realtime data from specific variables
Some PHUB188 hubs have a 100k instead of 10k temperature sensors, including the first
few batches of Fungineers hubs for balance vehicles.
Signed-off-by: Dado Mista <dadomista@gmail.com>
This commit enables cadence-based pedal assist for ebikes using
quadrature-style pedal speed sensors.
There are 2 operation modes:
* PAS only: Motor current is based only on pedal feedback
* ADC + PAS: The code will use both ADC and pedal feedback and use
the strongest command to provide seamless overlap when the user is
pedalling and requests extra torque with the throttle.
Signed-off-by: Marcos Chaparro <mchaparro@powerdesigns.ca>
This encoder needs x2 16bit SPI transfers so the hardware SPI peripheral
was used to run SCLK at 10MHz and reduce the ISR duration.
Signed-off-by: Marcos Chaparro <mchaparro@powerdesigns.ca>
* New "dist" terminal command shows odometer and trip distances.
* Odometer value is sent to UI via COMM_GET_VALUES_SETUP.
* UI can set the odometer via COMM_SET_ODOMETER.
* Unfortunately, the bootloader clears the odometer to 0 when FW is reprogrammed.
* Currently the FW code has CRC checks, but configs are also important!
* This helps maintain FLASH integrity when the config pages are occasionally
re-written due to odometer updates (later commit).
* If the config CRC checks fail, store the fault and fall back to default config.
* New 'crc' terminal command displays CRC values.