rusefi-1/firmware/bootloader

*** User Manual ***

To start the bootloader updater:
- Turn off your rusEFI ECU board, and connect UART to PC.
- Download "FLASHER-STM32" here: http://www.st.com/en/development-tools/flasher-stm32.html
- Run "STMFlashLoader Demo", set COM-port parameters (the same as in TunerStudio).
- Press the "Next" button.
- Turn on the ECU board.
- If the connection is successful, the next page of STMFlashLoader appears immediately. Press "Next" button again and follow the instructions.
- You can use:
  - Upload from device (Flash Read) command;
  - Download to device (Flash Write) command;
  - Erase->Selection command (only Sector erase is currently supported, not Full Erase!).

To update the firmware:
- choose "Download to device" mode;
- select the firmware file (rusefi.hex). Note! ***Use only recent firmware builds with bootloader support!***
- you may select "verify" option to check 
- you may select "Jump to the user program" to automatically run the main firmware after the update.

See STMFlashLoader_all_screenshots.png for more info.

!!! Note that the bootloader can update only the main firmware, but not itself !!!

Use this code on your own risk!


*** Developers Section ***

How it works, in two words:
- The bootloader requires a separate makefile because it's a separate binary executable with its own project settings and fileset.
- Start firmware/bootloader/compile_bootloader.bat to compile the bootloader code. Use it only if bootloader modification is required.
- The compiled bootloader code is stored in bootloader/bootloader_generated.hxx and it can be included into the main firmware (build/rusefi.hex) if the bootloader support is enabled.
- The bootloader support is disabled by default (USE_BOOTLOADER=no). You can enable it by adding "USE_BOOTLOADER=yes" to Makefile or "SET USE_BOOTLOADER=yes" to your Windows compile batch-file.
- When USE_BOOTLOADER=yes, a special version of linker script is used: STM32F407xG_CCM_bootloader.ld. It shifts 'flash' memory address to 32kb (0x08008000), and clears a space for bootloader at the very beginning of the flash memory. It also adds section ".bl" for the bootloader code.
- The file bootloader_storage.c used to include the bootloader code into the firmware (using '.bl' section).
- In result, there are two binary executables combined in one firmware: the bootloader starts first, and the main firmware start afterwards.
- All those can be overridden by board configs and makefiles - that's exactly how it's been compiled for Prometheus board.

The bootloader executable works as follows:
- Init ChibiOS and UART/Serial driver using tunerstudio_io code;
- Create a thread to listen to UART (thBootloaderSerial), using dfuStartLoop();
- The PC 'stm32-flasher' software sends its request byte only once, so we don't wait for it - the bootloader sends an answer as soon as it starts (both the request & answer bytes are known consts);
- If the next command doesn't come immediately (<100 ms), we abort the bootloader dfu loop and run the application code - calling dfuJumpToApp() in main().
- Otherwise, if at least one command is received, we stay in the bootloader mode and process commands.